1st Gen Lunchtable Thread - General Discussion

@CS_AR Which drawers are you running again?

 

ThErEs No SuCh ThInG aS a LeVeLiNg KiT

They're just spacers

 

Right right right

 

or you go the opposite direction

 

I'd whip the shiiiiiiiiiiit out of that

 

Would not work on the roads at work haha

 

Damn it looks good

https://www.youtube.com/watch?v=HLNEyQDatTI

 

Yaaaaa my windows 95 education isn't entirely defunct yet!

 

Yes sir! I did all my photoshopping in MS paint before photoshop even existed lol

 

Lexus just made a better Defender lol. Good on em.

 

Poking at the crawler little by little.

Fixed a vacuum leak at the carb and hooked up the vacuum advance again. Idles much better and sounds better off idle. Still waiting on the plugs and wires and I should reset the timing but maybe I'll be able to break 40mph after all

 

Dobinsons

 

Is the TX larger?

 

yet

 

Not sure, kinda looks like the Lexus version of the new Grand Highlander

 

Thanks. Couldn't remember. Was looking at different GX470/460 setups and their setup for the 460 looks nice.

 

It copies it to clipboard so I opened Paint and pasted and there's the screenshot. Not as easy as just saving it automatically but better than snapping your screen with a phone or camera so hey

 

@CS_AR Of course every annoying YouTuber had an upload ready to go. At least it gives a better look at both

https://www.youtube.com/watch?v=UfNjSa4QZKc

https://www.youtube.com/watch?v=TRKSl9tFaoE

 

Been doing some work on the GX. Cam tab gussets and CMC on the docket for today. Got some kickback on the grinder while near the rack and just barely nicked the boot. Has a small leak now. Wasn't planning on doing a rack while here but might be worth it while everything is apart.





I may have gone a bit soft on the CMC. Tacked in for now but I feel like I could get even more out of it, just not sure if it's needed. What say you?

Passenger stock...


Driver tacked...

 

@Wulf

Took me like 2 years but I finally put it on lol