What Have You Done To Your 3rd Gen Today?

That’s what I thought too. I bought my TRD intake during one of Toyota’s parts sales. Then I sold the reusable filter to offset the cost a bit more.

 

I took this issue into account when I designed my BDRM and incorporated a dual USB port mount on the right side.

 

New shocks.

 

The biggest change is the amount of volume of air after the air filter. The fancy top has more volume available if you compare them.The intake tube is a straighter shot to throttle body. The resonator is smaller so it must effect air flow or the engineers would not have bothered. I and other have removed it. Other on this forum have also added an additional intake port to the air cleaner body BEFORE the airfilter. I understand that the throttle body can only take in so much air but the least restrictions and the easier to take in air all help. If nothing else it sound better.

 

I haven't looked into it too much but what did you use to cap after removing the resonator?

 

I used a 3.25 silicone tube that another member found on Amazon. You will hear the engine
at WOT but at cruise no additional noise.

 

It did seem to add gas mileage but I didn't keep good enough records to swear to it.

 

67 Designs Taco rail with their cf nano arm and Trackform 20Lite phone holder. Have 2 more trackballs too that didnt install yet

 

What happens if you take it out ?

 

Towers for the Yakima rack showed up and was able to get it all mounted….

 

I can't even get 300 miles a tank. Wtf

 

Added some stickers and bought some taco balls

 

Need to get that KDMax 10

 

I solidly get 225 miles per tank. Before TW I could get over 300. Absolutely worth it

 

Right? This is what my 2023 TRD Pro came with.

 

I spent most of the day running new wiring for the dsp add on.
got the passengers side wired for the most part.
Running the wire through the front door grommet was pretty easy. A little silicone spray and the new wiring slipped right through.
The rear door was a PITA.
trying to run 10 gage wire through, with the little connector right in the way didn't help. It pulled the connector into the small rubber grommet and spent 30 mins trying to work it back out.
truck is all in pieces on the interior now, and just gonna leave it and start again tomorrow.
Figure I can get both wire runs made, then probably another half day to wire everything so there's no strain or rubbing.

 

Have a great weekend and enjoy your time off! I’m taking the 3rd off to make it a four day weekend. Dang, James Taylor on the 4th….it doesn’t get much more American than that!

 

Go for the trd rad cap and trd oil cap

 

I was motivated by these posts to modify the stock box a little. It's now a TRD 0.5 box. Cut the vacuum cleaner end off the intake tube and added a little extra weather stripping.
The only difference I see now is a slightly bigger box but the thinner plastic will allow more heat through.
The resonator box isn't only to quiet it down it helps absorb any back pressure. That makes me think the stock box and TRD will perform better than say a k&n (ducks from getting something thrown at him)
Potato Potato

 

^ This. Too bad I don't have the onions to tear into my dash....