What Have You Done To Your 3rd Gen Today?

Cali Raised Led step edition sliders for my 22 Tacoma are defective.

 

Do you have some pictures of this? My covers do the same thing..well at least the drivers side does.. mine are a few years old now and they seem to be doing this more and more.

 

Shoot, no I didn’t take any. I used three on each side. I did a loop around the bar itself, then ran a tie perpendicular through the loop and around one of the wires on the bottom of the seat.

 

You can probably make a mount to bolt to the molle to give you more lift

 

Learned FKS bearings come in 4 pieces....



they come in 4 pieces right???

 

Did you start with the 14mm bolt installed by the factory? The YouTube video Cali raised filmed for the installation is boring af but they don’t miss anything in it.

 

Never been happy with the GPS built into my 2017 Entune head unit so I mounted a 7" Garmin GPS to my BDRM.

 

lol... the front bracket is way off. I can't even get the slider against the side or the bottom of the frame to get the holes lined up. The 14mm bolt was my next step after I had the slider in place toughing the frame. But no can do.

 

It’s at that fucked up angle? Also it might square up once you get it closer to being in place, possibly. I would bend it before sending it back. I have installed a couple sets of Cali raised sliders. Freight charges aren’t fun.

 

Agreed. Freight charges suck.
Had he ordered a set of sliders and said specifically to make them not fit his truck, that would be one thing.
If you order something, you expect it to fit, and if it doesn't fit due to their mistake, they should be responsible for sending him a new working set, and if they want the old ones back, they can pay for it.
He's already paid once. Not responsible for their mistakes.

 

Gooood luck with that one. I bet all the freight charges would cost the same as the sliders. If not more.

I think next time I order something I’m going to ask to have it not fit my truck. I didn’t see that drop down option although.

 

it's around 200-250 for freight
about 1/4 the price of the sliders (roughly)

 

One way

x3

 

yup. and that cost is on them for sending him a set of sliders that were made incorrectly.

 

I can't square it up. It is as close as it's gonna get. that mounting tab is holding me off. Down and out from the frame. Wonder how I can bend the mounting tab down. Both sides are the same (driver side too).

 

Like I said. Goood luck

 

So you think it's up to the customer to ensure that the manufacturer makes his items correctly?

 

Maybe a vise? Vise grips? Lots of anger, but that shit never helps. I was wondering if if was laid in place if that tab would “suck up, and bend in place”

 

Exactly