1st Gen Lunchtable Thread - General Discussion

@Abeyancer

https://www.instagram.com/p/CuO4Ae6uRc8/?igshid=MzRlODBiNWFlZA==

 

You need to follow him.

 

Don't mind me and my invisible trailer

 

When you drive a Tacoma but are secretly a Ram lover inside

 

Save it

 

@eon_blue

Is that the same one we both saw weeks ago?

 

Looks similar....but that one was in OK I think? Not sure where this one is supposedly

 

Engine is knocking I guess

 

I remember a white single cab with old school graphics; what group is it in?

 

The one I remember seeing it in was that Toyota 4x4 Classifieds on FB

 

Oops I meant Jaxon

 

I can pick these up if you want

 

They're unfun

 

What press sleeve set should I get?

 

Are you determined to do it in a vertical press? Because it's notoriously hard to setup and usually requires more than 20t. I'd recommend the OTC hub/bearing tamer kit, screw presses don't struggle so much with them and it's easier to setup.

 

Nooooo,I don't even have a vehicle they'll fit into.

Just thinking ahead that's all.

 

No but I have a 20T press I bought over a year ago that I thought I would need but haven't used - if there's something better though I'm all for it. Just watched the Timmy video that used a press though

 

Grr I remember this guy making his own setup for pressing bearings into 1st Gen spindles. Uses an HF 20T press.

Local dude cause he buys spindles, puts new innards, and welds in that reinforcement; sells them for a huge markup to the fanboys on spacer lifts out here.

 

You can probably get it done with the 20t, just get your setup really stable or it'll slip under pressure and you risk deforming the spindle... Oh and you'll need a cheater on the press handle haha, 20t is barely enough.