What Have You Done To Your 3rd Gen Today?

First wash and wax and the first car/truck that was new I didn’t need to clay bar first. It was smooth as a babies butt lol straight from the dealer. I think since it was made in June and I bought it only a day or so after the dealer got it so wasn’t laying in the sun baking and getting water spotted. Made the first wax easy peasy just put a light coat of meguiars Ultimate wax after steam cleaning the under carriage and then washing the truck with chemical guys Hydrosuds SI02 Ceramic Car Wash Soap. Came out really nice and made the silver really pop but hard to see in the photos.

 

Got the same set up! Worth paying a little bit for a clean look.

 

Found a 3D printed plastic mount on ETSY. Has held up well for the past serval months. LacunaSolutions.

 

Shines like a new truck.

 

Got this close to done just need to finish the line and mount the chuck someplace I like better. I also wanna replace the switch

 

I have my moments

 

Where’s the “What did you do WITH your Gen 3 today?” thread?

I took the Diamondback off and hauled a Bowflex I bought for a killer deal

 

Thank you very much for this. I will be looking into this option. Looks super clean

 

Thanks man ! But It better since it is Only had her a week or so and just cleaned her up after a couple modest trail drives

 

Tuffskins RED letters for the tailgate handle TOYOTA and the glovebox TACOMA, Hellwig installed and it truely improves ride quality. No shaking when going through Boston's crappy pothole infested roads, a much tighter road feel on the highway. Only took about 90 minutes from start to finish...

I know... worthless without pictures... will post on Sunday...

 

they are great clothes hangers

 

I've got that same mount.

 

Yeah it looks like I’ll be going that route…it looks factory

 

You read my mind but it sounds good and can’t wait to see it

 

I will take any wheel that isn't black

 

Looks so good!

 

I have my compressor in the same place. I found it annoying having the air chuck at the compressor location as the air hose would come into contact with the hood prop. So I plumbed it to the front, just behind the grill.

 

I put ditch lights on my ditch lights…not sure how I feel about it, so share opinions if you’d like.

Baja Designs S2 Sports (spot/flood combo) with Baja Designs S1s (Flood) on the side of the S2 brackets. Stole the idea from Baja Designs IG post of someone doing it…looked better on their rig I think.





I think I prefer how I have historically ran my last three rigs; with just S1s for ditch lights.

 

Truck looks good just like that...

 

RCI trans skid went on, going out tomorrow to bounce it off some rocks!