1st Gen Lunchtable Thread - General Discussion

Yeah

Even that looked like it was recently changed when I replaced it a few days ago

 

Not sure they do anything anyway; I mean our AC filters at home yes for sure, but vehicle?

I've never pulled a really dirty one from any of my other vehicles.

 

I'm sure if my Tacoma had came with one it would have gotten filthy quick with all the dirt coming through the vents. But for most people probably not

 

NGL I didn't want a topper because of my deadbeat grandpa who had one.


I'm built different

 

Same; I do enjoy windows down whenever I'm out but only on colder/outcast days

Otherwise, AC full blast

 

sup fawkers

 

ate too much, tired now

 

v0.1 Ready for beta testing

Tailgates are a pain

 

Is that a mega cruiser?

 

At first glance it looked like the bed sides were slide out removable ramps. Then I seen the screws fastening them. Still looks nice.

 

Drove it home last night, definitely pulls better than the slug. Couple issues i noticed was a cv axle needing to be re booted, and she's a p wet setup underneath.

I will need to check the maf today, it has a bog/ surge when i get on it. Nearly dies then i change gears and the engine pops back into working again. The screw for the maf is coated in dirt and prolly hasnt been cleaned in forever. Will keep updated

 

You'll be happy to know my bed stiffeners have improved, for when you're ready for a set

 

Maybe for version 3. I think i'll cut the ramps down narrower, and build out a new front, and a proper tailgate next.

 

Get yourself a #2 Vessel JIS driver and a shorty for the TPS screws. You can get them on Amazon. Makes life much easier with a Toyota.

 

I see what happened here. You drove my van for 6 miles and just had to get a taste of the ol' blue oval for yourself.

 

Some kid brought his 99 Tacoma by my garage last night. It’s that truck I wanted to buy earlier this year that was in way better shape than my 99 as far as rust and irreversible cab damage goes. I’d planned to swap my entire wiring harness and 4WD/manual trans in if I got it.

Engine had 185K and a knocking that was most noticeable at the transmission tail housing and through the auto shifter. Figure it might be a mildly warped or cracked flexplate.

I adjusted his super loose throttle cable and fixed some small things but don’t have the energy to work on that thing since he wouldn’t be paying me.

 

@Tour991

https://www.instagram.com/reel/Cu6yqkQASho/?igshid=MTc4MmM1YmI2Ng==

 

Huh