What Have You Done To Your 3rd Gen Today?

Also, they are super similar in quality of build and design of the All Pro Off-road ones I had previously but for about $50 less

 

To be completely honest I had decided to stop making spacers because the market is saturated with the round and square spacers. It is more of my retirement hobby than a source of real income. No sooner than I made that decision I took another look to see if there was any way to improve current designs. Then I realized that, even though I thought my originals were the safest design, there was a way to make them safer. What I like about these is that, even with no bolts installed, body weight alone prevents these from coming out. When bolted to the floor I do believe this design is the safest ones to have, under the rear brackets, in the event of an accident. It is the 1st of its kind and I have even contacted a patent attorney and am currently drafting a design patent application package.

 

Smart to get a patent on these! Knockoffs would definitely be coming unfortunately without it

 

They look similar to the total chao ones too

 

Yesterday I replaced my spark plugs and updated my tune. Today I made some brackets and doubled my solar capacity, ha. Up to 200W now. And I added a grab handle to my tent.

 

Rolled 40K on my 2018 ..... celebrated with a bath and a rub down....

 

all pro versus 1320. These should also work with the d ring but I’ll explore it later today

 

Beautiful truck!

 

TY sir.

 

I bought 36 square feet. Each sheet is 16" x 24". I ended up with three full sheets and a third of a sheet leftover. I was hoping 36 square feet would allow me to do behind the back seats but I'll need a little more obviously.

 

I'll give it a go but I'm honestly not sure exactly where it's wedged. I was thinking about just waiting a few months, hoping it'll work it's way down to the bottom of the inner door. Haha

 

Thanks. If it does then I'll be getting a set soon.

 

Sounds good

 

Made a custom $30 hi-lift mount on my Rig’d swingout, it sits outside now where I can use it -Ryan (shmellmopwho) made a awesome bed mount for me for it but now I use that for my pull-pal winch anchor. Having the hi-lift more accessible was a better choice.




Heavy duty L-Brackets and hooked bolts from True Value.

I made the cable lock.

 

Looks great. What solar panels are those?

 

Put this little guy in yesterday. Used the GTFO bracket. (Wish I took the air filter box out first tho, because getting the far side attached was annoying)

Going to wire it up today.. I going to make a custom harness for the switch.

 

Confirmed. Retains the factory D rings.

 

Confirmed these do as well. So options for people