What Have You Done To Your 3rd Gen Today?

Welp, I found the stupid little clips on Amazon. Got 20 of em for seven bucks....now I have 19 that I'll likely never need.

 

Ok you made go look again and re-measure
https://i.imgur.com/b3u0Ewo.gifv
This time I measured from the roof at entry and the shark antenna again. My measurements are accurate and should be good to go
The pictures make it look tighter than it is and again I measured about 12” from shark fin to door frame the lowest point.


this picture below captured the accurate appearance of clearance.

 

Until you pull that cover off again .
I put some electrical tape over the holes and then cut a small slit in the tape. That kept the clips from falling inward again.

 

Todays excursion into making my SR do things SRs aren’t supposed to: AUTO LOW BEAMS!

I know, they are standard now, but my 2019 didn’t come with them. I can disable them at anytime, and the headlight stalk switch still works like factory if they are disabled. The pictures don’t look like anything exciting, but to me it’s been a long road here