What Have You Done To Your 3rd Gen Today?

I'd like the ECT button on the steering wheel.

 

New Sony 6000 and Memphis speakers front and back…

https://www.memphiscaraudio.com/car-audio/speakers/pr-speakers/toyota/

 

This is pretty good, and way easier to find when you need it.

https://mesocustoms.com/products/stealth-pro-shift-knob?variant=21433407438961

 

Rotated my tires today, bought a torque wtench to tighten them to spec, and repaired an old plug that wasn't holding up too well. I tried to take off all 4 tires at once but trying to get jack stands and a jack to fit under the control arms together was a pain in the dick, just wasn't happening. To I stood the rear and had to switch the bottle from LF to RF in the middle of the swap.

 

Well haven’t done anything with it yet ..
But just found out my new wheels came in so the lift and 33’s should be complete in a couple of hours so I’ll be driving it home soon

 

I hope I didn’t go too high ?

 

Yes! Was a pain to route the wires, but once done, it so much more intuitive then the factory location.

 

Did the diff drop on my 2.5" lift, whether it truly needed it or not. I was diving into threads about the needle bearing and I swear I could feel premature wearing under my left foot while driving.
CV is much flatter. Feels better now.
Edit: There may be better insight about CV angles out there. Best I've found so far is a 22-30ish degree MAX angle of axle, depending on trim.
If that's measuring the axle angle straight up then I'm at 8 degrees.

 

Not too much today. Vent shades (a must in Florida in the summer) and LEDs for the hi/lo fog and backup. Waiting for sound material to install the front door 6x9s tomorrow hopefully.

 

Yeah the shifter is a great place i added a button to the non pro knob

 

Looks slick! What an improvement

 

I’ll be refreshing the page waiting! I love seeing 3rd gen. tacomas with aftermarket wheels and lifts

 

I figured Paul Reubens did the tequila dance on the tonneau.

https://www.youtube.com/watch?v=BodXwAYeTfM

 

Your wait is over and so is mine

 

What did I do to my Tacoma today?

Got news of a set of 4 SCS BR6 Stealth Indigo wheels directly from SCS and bought them. Should arrive around the end of September. Now I have to decide between the Stealth Indigo BR6's or the teal Falcon T8 seekers. Maybe a different color on each side.

 

Just picked her up and stopped to get gas.
Here she is with her new shoes and lift.
Absolutely love it and it’s exceeded my expectations in every area.
Drum rolllll ….

 

Some quick pics

Edit: Thought I’d add a before picture when I dropped her off for the transformation

 

I have that film. Don’t waste your time. Replace the clear plastic and ceramic coat it. It lasts better. My clear material despite being spotless still found bubbles an dust under it.

 

Got my results from my first Blackstone sample. Happy with the results