22’ Tacoma no start condition. Random after engine is warm.

Lately I’ve been having this issue where I put the key into the ignition and I get a no start when pressing the clutch and turning the key.


It is usually remedied by removing the key and restarting again.

Most noticeable when starting when the engine is warm.
Don’t think I’ve ever had a cold start with this issue actually. Starts nice and strong cold with a smooth idle.

Today was the most annoying occurrence when filling up gas.

72 degrees. Outside.

After driving 3 miles Won’t start when filling/pumping gas from 1/3 to full.
I did put 87 in after filling 92 last time.
Started two times before to drive. First about 1/2 mile. Second around 3 miles. No start starter after second drive and then pumping gas.
Sorry for posting on 1st gen forum ahead of time..

 

Wrong section. Repost in 3rd gen or have mods move it.

 

Sorry everyone. Was super tired when posting

 

Wrong section, but sounds like you should just go get the dealer to deal with it. That truck has to be under warranty right?

 

Do you top-up your gas tank all the time?

 

I would avoid topping off these ......unless you like engine evap codes....

 

Just in case no one's mentioned it, wrong section

 

Make sure the clutch pedal is all the way to the floor, especially if you have aftermarket floor mats. Also try the Clutch Start Cancel Switch when it happens just to be sure.