2LM PnP - Plug and play 2WD low range for the 3rd gen. Tacoma

Correct, standard on/off, not momentary.

 

Who's giving you trouble? I'll fight em.....

 

California.

 

Visor cards will be available again for both MT and AT in the next few weeks (hopefully sooner). I am just waiting for delivery at this point.

These will still be included at no charge with harness orders, however if you did not receive one, or need a replacement they will be available for purchase. As the original batch of cards were a wonderful contribution from another forum member, I can unfortunately not give away any of the new batch.

I will make an announcement when they are live on the site.

 

Does anyone know if toyota changed the visors by 2021? My 2021 does not seem to have a pocket for the visor card to go in.

 

Dammit. That is some good stuff right there. I had no luck trying to gently remove mine. Stickers were not a lot of fun to remove, but they have been gone for a long time. So much nicer.

 

Yes, it was covered a page or two back. Newer trucks do not have a visor pocket.

 

Time to start visor modding

 

just ordered. i may have missed it but is there any notification light/LED or dashboard status that indicates when it is engaged? would be nice to have a switch that outputs a little orange LED like some of the other switches... does this exist?

 

Not possible to show actual status on the gayge cluster. It's all over Can bus and not easily accessible.

 

so is a switch with an indication LED possible instead of gauge cluster then?

 

That is the default. When the switch is on the top will illuminate. The bottom is always on without tying it into the truck illumination circuit.

 

perfect, i didnt realize the recommended switches included that feature! thanks for the reply.

now i just regret not getting this years ago. my poor clutch from all the slipping in reverse

 

This MOD is clearly high on the 'best of' list... Thank you @lapoltba ! - I always highly recommend it!

I'll mention that in addition to the issues addressed in the thread (i.e. Reverse while towing), I find the mod super useful while off road.

I find myself on some pretty steep and tight winding off-road climbs with ruts, cobbles*, etc. which would necessitate a bit of clutch to negotiate. Being able to slow-crawl and avoid bouncing around over these obstacles is great.

-It is also it is quite helpful when on the types of steep slopes where the 1st - 2dn gear gap becomes relevant (annoying because you need gear 1-1/2!). Having the ability to use the low gearing changes the ratios more than enough to eliminate this 1st-2nd gear issue very nicely.

Using the low gear without binding while turning tightly on surfaces that still provide a good amount grip in 2wd makes for very clean climbs avoiding all drama. - No bouncing, slipping, need for engines revving, etc. while looking for momentum. The low gear torque takes care of you instead of the momentum. (Some may find bouncing up a slope entertaining, but when in remote places, you try to avoid breaking stuff...)

I don't know if others are also using it in this way. I've found it quite useful.


* Cobble: A class of rock defined on the Udden–Wentworth scale as having a particle size of 64–256 millimeters (2.5–10.1 in), larger than a pebble and smaller than a boulder.

 

I use 4Lo when off road lol

But Just yesterday I dated to use too low to break my rear drums for you, had a bit of flooding here recently and had to get the truck through some pretty deep water. And like a super smart clown. I did it and drive it the next day because I drove the other one to work and the rear drums were binding up again. 2lo to the rescue

 

This is what I use mine for, it is really nice to have the low range of 4low for steep hill descents with sharp turns.

 

2LM visor cards are finally available again. The first batch from the printer were hot garbage so they took their sweet time reprinting them. The new ones look much better.

All 2LM orders will include a free visor card (must make selection when adding to your cart). They are also available to purchase for anyone that has not received one.

If you have any issues with the site please let me know.

 

Looking to purchase two of these kits. One for myself and another for a buddy. When I add two harnesses to my shopping cart the shipping doubles. Is there a way to bypass this?

 

My store setup isn't flexible enough to allow for combined shipping. Please PM me your email address and shipping information so I can send you an invoice.