1st Gen Lunchtable Thread - General Discussion

If I score a cheap 2' x 2' 1/4" I may try this file out

 

@Kwikvette
https://youtu.be/_X-7CKeyasU?si=2B1mrYuhULedqIjG

 

Smoooooooth landing

I haven't gotten to even mess with any of those instruments to really know what you were doing; in time!

 

Like butter. I swung a bit wide on the approach and drifted off center line on touch down but overall it was a good one.

All I was really messing with is the range of the screen to zoom in and adjusting the heading and decent rate on the AP. From there it's throttles and flaps for speed control.

 

My thorleys on the 01 weren’t terrible to install.


But honestly I’m leaning doing custom headers for it when the time comes. The old thorleys can go on my 95 I guess if I go that route. We’ll see

 

My complaint about the thorleys are that they block access to the engine mount and bellhousing bolts. Hell one of the starter bolts can't even be fully removed with them installed.

 

Badass.. Nice flying and landing.

 

Honestly I really wish I could find a set of the Edelbrock headers… I would love to see how they fit. Since the crossover went under the transmission

 

literally the only thing i can find on the edelbrocks.

 

That must've been one tight fit around the driveshaft and steering shaft. Also wouldn't you lose clearance on that cross under? I dunno, were these for prerunners only?

 

i found instructions. 4x4 or 2wd. it had to be close.. but i cannot find photos of the kit installed on anything.. i dont care about the crossover so much. im genuinely curious how much room that collector had by the steering shaft.. i'd love to run a proper dual bank setup when the 01 goes haltech..

 

https://www.manualslib.com/manual/42469/Edelbrock-6607.html#manual all i can find digging. surprised these oddballs seem to have been lost to time. wonder if enola on CT has any info to share on them

 

Could be a guinea pig and see if the Aussie Prado 3.4 headers fit. Looks similar to the Edelbrock.... but you never know they may have not planned around a steering shaft, but they had to plan around the driveshaft at least. Only so many ways to skin a cat

https://www.ebay.com/itm/2853074309...AT15Wc-R3e&var=&widget_ver=artemis&media=COPY

 

eh its a project for later. i will probably end up going custom on them IF i dont just toss the thorleys on



those prado ones look eerily close to the edelbrocks though

 

Thanks. That was just a hop and a skip north of Golden BC. ended the route in Invermere which was fun. I have a fun approach and landing that I will share tomorrow that i think is fun to watch. I should do some recorded landings at some places you and I have been to before. I am sure you will recognize some of the places.

 

Starfield high key pissing me off now with its lack of adequate tutorials...
I'm what? 6 hours in (cuz I've been playing casual) and two of the primary quest lines I've gotten to the waypoints with no idea how to progress?

I'm all for throwing a gamer in the deep end, but ffs if you have a storyline at least put the controls on the screen for how to progress

 

Have you replaced the starter on your Tundra yet?

 

I really need to spend more effort setting up my table and tuning my feed/amps to the material....

I've been cutting everything at 30fpm and 30amps lol

 

YOUR SOUND CARD IS WORKING PERFECTLY.



good ole Warcraft II