1st Gen Lunchtable Thread - General Discussion

Wait, did i miss something? Did your Taco get totaled?

 

@treyus30

 

*2500

 

If you could make the third one a holder for discs that'd be sweet

 

oof

 

I know, I know, actual fabricating

 

From my understanding, that's where everyone has to pull timing though

 

I don't get over 5lbs with the way I have my curve fenced there so my timing remains pretty normal. But yeah if I was edging close to double digits there I'd be pulling a bit...

 

Not so much that, becuase of the size I'd have to use steel I use for customer pay jobs so you'd just be buying into that

The file is basically 95% done based on your needs.

 

@treyus30

Just got rid of the 'u cut out' and put a hole so you can just weld in some solid steel rod to hang your discs on







Figured you can determine the length of rod as god knows how many flap discs and grinding wheels you go through

 

Is this poorly thought out graphic design or subliminal messaging

 

I think I've seen it mentioned in the SC thread a couple times, but I'm not constantly following it

 

The only spot I pull a "lot" of timing is peak torque at 3800ish. That said my whole timing map in boost is a bit conservative, realistically I think I could up everything 2* safely and not even be close to danger.

 

I'll probably start messing with timing again here soon. I've just been letting it adjust to all the new lambdas and I don't drive it much. Would be nice to get those knock sensors in too beforehand, I just hate having the truck down in case I need to go grab a bunch of bulky stuff from Lowes for the house

 

But that's not even at my redline

 

Be careful German cars can hear you and are very spiteful in nature

 

....mine either