Fox 2.0 Performance Series Front lift height.

What Lift height are you getting out of your Fox 2.0 Performance in the front?

I just purchased them and on the Shock Surplus site said they are 0 - 2" lift.

I didn't fully do my research and it looks like for the gen 3s its only a 1" lift.

Anyone here Adjusted theirs to be a 2" lift on Gen 3?

How much thread are you showing to achieve the 2" lift?

Thanks in advance!

 

Well, that sucks....

 

Until a better answer comes along, I was under the assumption they should reach 2". Less if you're carrying extra weight or they settle some. Wouldn't think they would settle a full inch.
I'm at 2.5" with a leveller right now.
Looking at the fox 2.5 factory series because they go to 3" and I should still be able to get 2.5" from them even if they settle.
Where or what got you thinking they'll only raise a 3rd gen 1".

 

I have fox 2.0s (0-2") from shock surplus also. I did not adjust them and installed them as they came. If I recall I got about 1.24" of lift.
as mentioned I didn't adjust them but there are lots of threads above to play with - of course with the sacrifice of ride quality

 

I believe they are able to reach at least 2" but I don't know how good that would before the shocks being over extended than what is specified.

 

are you showing about 2 3/4" of thread? Thats what mine shows right now.

I was hoping run 2" lift in the front and 1.5" in the rear.

 

just about! 2 5/8ths

 

Thank you. I’m still debating if I want to sell
What I have and get the 2.5 to get the extra lift