What have you done to your Tacoma today? 1st Gen Edition

The answer is yes, yes it does come with a wire harness

 

I like these wheels, haven't seen them many times

 

what wheels are those?

 

To build on what Zane said, you can use a relay box in the engine compartment, and make the triggers two switches power tapped off one of the ignition-switched fuses under the left leg fuse box.

[Add-a-fuse (5-10A)] ------[driver seat switch] -------- [Relay box trigger 1] ----- [GND]
.................................^----- [passenger seat switch]-----[Relay box trigger 2]----^

[Battery] ---- [[15A fuse]-[Relay 1]] ----- [Driver seat heater] ----- [GND]
[Battery] ---- [[15A fuse]-[Relay 2]] ----- [Passenger seat heater] ----- [GND]

 

Do you have the wire mesh installed in there? I had that model minus the filter, but I would get those symptoms on the filter where the driver's side vent is. Went to a double-input catch can with the baffle and no filter, just a hose out to the wheel well, and haven't had the issue since. (and hose is dry)

 

scs blaze10 copper finish with 285 70 17 falken mts

 

I'm gonna have to give those a deep think

 

theyre basically ray10s and i like them a lot now that they dont have the fake bead lock. tons of cool wheel designs out there but for some reason all sold out =/

 

Those bastards are always sold out on all their rims. I had to watch like a hawk for 6 months to get my F5's

 

I blasted them a bit on here for not having pics of all their colors. Their response was bs. But ya I think the copper would go great with the blue I have, and the blaze 10s were already some I was considering. Looks like that combo is out of stock rn as well

 

It's in there

 

Thank you! They’re from an FJ, I’m happy with them.

 

Got the driver seat from the upholstery shop and the rear jump seat cushions with new leather and the heated seat pads installed.

the 7.5 amp CB holds when both seats are on high.

My Taco is ready for the winter to keep my buns warm.

Mike

 

Oh reeeeeeaaalllly. Interesting.... very interesting..

 

Does that mean you're going to sell me the other kit?

 

I've got the same issue. I just always have the recirc on. Mine isn't filtered, just a hose dumping out of the catch can. I used to have it plumbed back into the intake but was running into freezing issues and still do but not as easily.

 

Ooooo this could be interesting too. I might have to reach out to Matt.

 

Can you elaborate on the freezing issues? I have mine plummed backed into the intake as well without a filter on top like that.

 

The 96 got new ball joints, 270,000 miles on the originals and finally started getting some movement with the prybar.

 

Starting the collection of parts for the 4x4 swap