Tacoma SR fog light Install

I watched a video showing how to install fog lights on my SR (not prewired) by splicing into my low beams. This appears to be a much easier method, I would only want them on when my high beams are on anyway. Does anyone see a problem with this method or any suggestions?

Thanks in advance!

link to video:
https://youtu.be/wuPxG9KOwYs

 

welcome

so wrong
1) fogs should only be used when needed in bad weather
2) fogs are only supposed to be used with low beams, fogs with highs trick your eyes out of distance vision (driving lights are to only to be used with high beams)

the fog light review thread
https://www.tacomaworld.com/threads/the-led-sae-j583-fog-pod-fog-light-review.554813/

there are a few threads on adding fogs to SRs with out wiring

 

Sorry, I meant I only want them on with low beams. As the would be spliced on the low beams to only come on when they are on.

 

OP, did you indeed verify you are missing everything or somethings?
Nitori's OEM SR Foglight mod!

 

I looked at it again today and I guess it is pre-wired. It even has the relay for fogs under the hood. I'm a little leery of pulling my dash and steering wheel completely out of a brand new truck just to get fog lights. I was hoping there was an easier way.

 

There is, read some more on the link. Dash switch to complete ground and you're set. Harness from center of front bumper to fogs.

 

I'll look at it again. Thanks for help!

 

I've been meaning to check if my SR is prewired or not. I've always been annoyed that fogs are considered a 'premium' addition, they're an essential item IMO.

 

"Logical"