Glock owners united MEGA THREAD

Why'd you sell your mags to move back to Oregon?!?! All the mag capacity limit crap is on hold at least until the court hearing at the end of September and anything in current possession will be grandfathered in IF it does take effect.

You should stock up on some standard capacity mags while you can!

 

I have plenty of standard mags, around 20 or so. I moved back to Oregon and sold my 10rd mags (I had to live in a mag ban state for work for a little while) and because I was short sighted (wasn’t paying attention to their upcoming legislation at the time) I didn’t think about traveling in Washington and being compliant up there.
Edit: probably still going to buy more standard cap mags for all my firearms though.

 

Ah that makes way more sense! I misunderstood that you sold all your standard caps to move to Oregon and only had 10 rounders now.

Welcome back!

 

No worries! Glad to be back!

 

I am looking to some Minus connectors for a couple of my pistols.

Are the aftermarket ones as good as the Glock ones? Or should I stay with Glock parts?

 

As in a trigger connector? I’ve only ever used parts from glockstore or lone wolf personally

 

^^^^^^This^^^^^^

 

This is the one I use and can highly recommend:

 

Ghost Evo Elite.

 

I prefer OEM Glock ones. Just a preference thing.
I sent my trigger out for work. Installed a slave pin and a travel stop.
Smoothed everything out. Removed pre and post travel. Crisp wall.

Was also paired with cleaned up facory connectors and safety plunger so I can adjust the pull weight.

 

Simple little set up.

 

Stock guts?

I've upgraded a couple of parts on mine, and need to polish things.

Unfortunately, the Trijicon suppressor height sights do not clear the Leupold Delta Point... I need to either change the red dot or get a milled slide and not use the adapter.

 

stock guts. I'll probably get a overwatch precision trigger for it like all my other glocks. You should look into Galloway precisions for their rear DDP rear sight insert. Also ameriglo makes 5xl height sights that may fit the bill. Or run what you have and spend $90 and have the slide milled.
I'm not a fan of plates so I always get them milled or find a red dot that works directly on the mos cut away without a plate.

 

The plates seem to be a good idea from the manufacture's point of view, but any height of the sight that can be reduced is a good thing.

 

Sell the plate and mill the slide. The hopefully you can keep you sights you have now.
Wager Machine works does my slides and has a huge following on Reddit. NEVER seen a negative review.

 

There's a market for plates?

 

Is it just the MOS plate or is it one from say CHPWS? If it's not the MOS plate then yes, people will buy it.

 

It's the stock Glock plate. I've looked at upgrading it, but haven't yet.

 

Since it's the mos slide not sure you can remill it to a ddp foot print so you're only option would be to buy a new slide that's milled or have it milled. Or somehow find a much much thinner plate which probably will still be too thick.

So back to square one, and maybe just finding taller sights or using the ddp rear sight insert.

 

This is a back burner project, even though I have shot the gun in several matches. Guess I need to move it up the priority list...