Do we know the bed dimensions yet?

fingers still crossed that the length and width on the short bed are the same, at least where a tonneau cover would mount.

 

Great news, with a minimal upward spacer, I can still use my pop-up camper.

 

How do you get a reasonable mount for a shell with that weird 4 runner spoiler on the back of the cab??

 

Google some camper shells on the new Sierra/Silverado. They mold in notch for it.

https://www.4are.com/view/gallery.php?tmake=Chevy/GMC&tmodel=Silverado/Sierra&mk=c_s&vw=t

 

Thanks. Just what I want, to look more like a GMC!

 

Really want to know if Leitner racks will transfer between 3rd and 4th gens without modifications

 

You should call them. It just uses the side rails with t-nuts?

 

I have already contacted them and they have no answers until they get their hands on a 2024

 

It should fit. From what I’m reading the Leitner from a Tacoma should fit a tundra (cross bars say for Tacoma 60” wide).

I transferred an UpTop 3rd gen Tacoma rack to 3rd gen Tundra just by getting 60” cross bars. 4th gen Tacoma rails look the same as previous gens.

 

I have searched web everywhere for an hour now, and can't find 2024 bed width AT TOP OF RAILS. I want to know if my canopy camper will fit from my 21 tacoma to 24 tacoma, or will bea few inches too narrow to sit on rails now. I can't believe no one posts this critical measurement in all the hundreds of reviews...

 

You’ll likely need to measure yourself. I’m curious if my tonneau will work, too.

 

From Toyota's own spec sheet on their website. It's a start.

 

@stk0308 , good find! Accessory rail is closer to top than the base, and the sides do flare out.

I just found a single 24 SR5 on a dealer lot 10mi from me. Was gonna drive over today and measure, but if I dont get to it, this helps!

 

FYI

 

@JB_TN thx. I'm hoping that since my camper sits on outer edge of my bed, and has flats extending inwards, that it will still be properly sealed and supported on 4th gen. It will be a matter of an inch or two, hence the measurement. I can't believe how hard it is to get this top of bed rail width, considering how many people have toppers and tonneau and campers and bed racks, all requiring to know that width. You'd think one of those aftermarket companies would have measured and have it on their sotes, but I've looked at 30 or so and can't find it.
Instead, every post has track width and wheel base, which affect absolutely nothing else, and anyone will just take it as it comes.

 

@Visa_Declined Can you hook this guy up with what he needs?

 

He’s likely sleeping. Graveyard shift sucks. He’ll probably reply at 3am.

 

Here's what I found on my 24 TRD Sport with 5' bed.
Measuring outside to outside of bed protective top cap at front is 64"
At tailgate is 61" (gets narrower from front to back)
64½" from front of bed to back of tailgate protective top cap (on top)
Bed is 52½" W x 60½" L inside bed dimensions
Bed is 20¼" deep and 39" from bed to top of cab
The contoured lip sticking out at back of cab at roofline sticks out 1½"on the sides and curves out to 2½" in the middle

 

Do you have the INSIDE bed width, at the top of rails? You gave the tapering outside width, but it is the inside width that determines if a topper will sit on it still, or a camper shell. Thx!

 

is this what you are looking for?