1st Gen Lunchtable Thread - General Discussion

Then you defeat the purpose of learning how to take lines the right way

Seems you don't want to learn, you just want to push through

 

I only asked cause my log in has full solidworks (as in a ton of shit) and I don't even use it

They have training tools/videos but my attention span is too short and I end up opening Fusion to make some other dumb shit

Just a shame the program isn't being used

 

leaf springs are hard to keep quiet, noisy TOB is a pretty common one too especially if the clutch was replaced and they didn't use an OEM one

Did u clean the PS pump screen and give it fresh fluid? Usually when the screen is clogging up it starves the pump and causes the whine and you can catch it before it kills the pump entirely

 

No I ended up taking the right line. Last time
I straddled to the left like you said. Lockers can just be a cheat code on mild to moderate trails.

 

Did you air down?

 

haha if I hit a wall I'll let you know

I have a 1st Gen bedside tool mount design on my mind for a couple months. Might take me a couple more to consider starting it

 

And...lockers should be used to help overcome an obstacle where you're already taking a safe line, but the obstacle is just a lot harder in general

I've seen some gnarly shit done on IFS by many even on just 33s

For mild stuff, many don't even find themselves going 4L at all, just staying 4H for awhile

 

I was at 14 PSI, but I felt like I could’ve gone lower. I tried driving up an optional rock ledge later on and the tires couldn’t quite get a purchase on the rock.

 

What's "air down"?

 

Ooh badass

Kwik Fab & Wulf Industries Collaboration

 

I took a buddy out to crawl after helping him upgrade to 35s and it was difficult to convince him to put it in 4lo... Until the trans temp warning came up on his dash lmao

 

Kwik fab collab

 

Ok there is a time and place for sure

Doesn't sound as bad as the Jeep crew on 40s

Creating deep AF ruts in the snow/mud for us to overcome only to block the trail cause two of them overheated bouncing off the rev limiter a bunch

 

it's when you let off some steam after eating too much venison

 

Oh ok, yea I air down

 

@Speedytech7
@0xDEADBEEF

Your favorite software for disk cloning either of you have used?

Only asking cause there are tons out there but some bloated with adware and other shit.

 

clonezilla

 

Hell yeah

And I hate that you mentioned Unreal Tournament cause I remember playing the shit out of that too as my replacement to Quake

Wanting to get my retro game list going

As part of that list, I'm following your suggestion and Kira's on the older Fallout games

They're between $2-3 on Steam

 

You can skip Fallout 1 & 2 unless you're really into turn based isometric RPGs, 3 and New Vegas are worth getting the full GOTY versions, 4 is meh but some people like it

 

I'll grab those then

The requirements are easily handled by the Quadro per the specs recommended