Push button start

The damn button is stuck “in” and won’t come out. Has anyone else experienced this??

 

No. Perhaps try a suction cup and see if you can pull it back out. Anything sticky spill in the truck?

 

No spills. It tries to come back out and stops about an 1/8 of an inch in.

 

Dust and dirt try some silicone spray to wash out the dirt .

You might need to remove it for a good cleaning

 

It has 1,900 miles on it. No Off road yet. Not my daily but runs daily. It’s practically show room.

 

Just wondering if anyone has experienced this as there is no logical explanation other than improper function.

 

Under warranty ??

Take it in and get your switch replaced.

 

so it is acting like your continuously turning a key? what is happening?

you get in, put your foot on the brake and the starter starts turning? I would be asking the service manager, and drinking free coffee at the Toyota shop.

 

don't matter then. it's a warranty problem.

 

No, it isn’t trying to turn over. The button goes in, stays there and nothing happens. I go back out 1/2 hr or so later and it’s popped out. Yes, taking a trip to service…

 

Yes…

 

Good luck getting your warranty service