Truck won’t start after electric mods completed

Truck will not start...
I had the driver side kicked panel off. Trying to find a reverse trigger wire. And I was using a teslight to probe around at some of the wires. Nothing major at all, no sparks. Nothing and I went to start the truck and it won't start..
I've checked every fuse in the eng compartment fuse box and under the dash....HELP PLEASE
2023trd 4x4 or

 

1. Multimeter the battery, verify that you have a good charge of 12.5 V and that you didn't drain the battery when futzing around.

2. Did you check fuses visually or did you pull and test them with a multimeter? Blown fuses can sometimes be tricky.

3. If all else fails, put the kick panel back and have it towed to the dealer.

 

I have to ask the obvious question. Is the battery dead?

 

Brand new truck? Get it towed to the dealer. Don't let them blame you for any electrical issues!

 

Battery is fine. This is a brand new truck and I did not drain the battery... I checked every few with a Continuity meter they are all good...not in the mood to tow my new truck...

 

It cranked till you probed some wires.....?

 

My problem is they will blame me i've already Put on a germes and other mods ...with a few tap a fuses under the kick panels...

 

Your best help will come with a proper thread title. "HELP" is reserved for people in imminent danger/stuck on a trail/lost/etc.
Maybe something like "Truck won't start/possible short near driver kick panel" or something similar.

 

Yes it cranked I pulled it out in the driveway this morning now it's stuck

 

When you turn on the switch does the instrument panel light up...does is show what gear its in?

 

When you say won't start, what do you mean exactly? No ACC power, clicking noises, trying to spin over but won't, etc?

 

does it crank or do you get nothing at all?

 

Hey guys, ok, so when I turn on the key? Everything lights up, there's power to everything. Radio works but it does not start. It does not crack nothing. I put my OBD reader on it and I'm pulling up Apo 452 code.help wtf

 

P0452

 

Does it show what gear it is in?...

 

If you were doing electrical work and didn’t have the battery disconnected, it’s possible or even likely you blew a fuse somewhere along the way.

 

Is your gas cap tightened correctly?

 

Yeah I thought the same thing I just tighten my gas cap it was tight

 

Here's a wild question; when you added the 'tap-a-fuses', what fuses did you tap into? Start there.

 

I thought of that also and they all still work