2002 tocoma pulls to left when braking

Did you bleed the LSPV?

 

Nope
I found out too late about bleeder on LSVP
Then searched and general consensus of members here/vids said that the LSVP fails regularly

so, hence next project……

 

I have not yet

 

Ok guys so I didn’t bleed anything but I found out my emergency brake isn’t working properly the driver rear is working but the passenger side isn’t working at all I was in neutral on a hill and tried to use it and I was just rolling down it and my front calibers for the driver side the temp is 180 and the pass side is 148

 

Given how much difficulty you've gone through I think a rear brake refresh (drums, shoes and hardware) would be a good next step. Include the bell cranks for your parking brake as well.

 

That’s where I’m leaning at now I’ve made a appointment for the truck I’ll let you know next Tuesday evening

 

Ok guys so I’ve been trying to figure this truck out and I’ve seen the driver side rotor is 180 degrees and the passenger side is 140 ish truck is abs and I’ve also figured out my emergency brake doesn’t work as well one wheel locks up and the other doesn’t could this be a possibility of the pulling to the left when breaking??

 

Yes take the rear drums off and look for broken hardware or unevenly worn shoes. Adjust both sides until there is a very slight drag spinning the wheel by hand

 

I had them checked they said they were legit brand new

 

Then they adjusted the break cable and it’s still the same one side still dragging

 

Well somethings not right if one side locks up and the other doesn't. The brakes need to be doing an equal share of work side to side. If not, that's when things start pulling

 

That’s exactly what I think I’m taking it to a Toyota expert Thursday so I’ll see what he has to say

 

You don't need a "toyota expert". Disc brakes and drum brakes are all pretty much the same.

You just need somebody that understands how brakes work, and is willing to investigate and put in the time to find the problem. Avoid any place that offers to look at it for free

 

Yea this guy hasn’t done me wrong just very expensive

 

That's OK, throwing parts at a problem is expensive too..

 

Yea tell me about it every part on it in the front is replaced

 

Pads and rotors ?

 

Yes sir both replaced

 

Have you verified that your control arms are nice and tight with no slop. I had a similar issue on my truck and my lame mechanic didn’t torque down the control arms to the recommend spec and one loosened up over a few hundred miles. I learned a good lesson that day hehe. Hope ya figure it out!

 

That was the problem for me they bushing were bad and got replaced then the pull came back but my emergency bake isn’t working only one side locks up and other side still goes