Does Anyone Make Extended Front ABS lines?

I tried routing the wires every which way, but still pulled fishing line tight at full droop. Getting connection error on one now. Does everyone just make their own? Also, I never noticed this before, there are 2 wires come out of the sensor, but if you follow the wire to the plug in the wheel well the other side of the plug only has one wire on the other side?

 

I have tried to make extended lines before, and not had success.
It’s very thin wire, so a bit tricky to work with if you aren’t good with soldering and clean work.
I’d look at trying to disconnect some clips near the frame if you can, get some extra slack for the droop.

 

Guess I'll just have to buy another OEM line and try to rerun it. Still wondering why there is only one wire on the other side of the plug, but 2 wires coming from the sensor?

 

They have a pigtail for the end that connects to the sensor anyone ever found a pigtail for the end of the cable?

https://www.ebay.com/itm/134159086366

 

The schematics show two wires all the way from the sensor to the Skid Control ECU for each sensor. You probably found your problem.

Edit: Or it could be a shielded one conductor cable too? Much like a coax cable?

 

@jboudreaux1965
Your signature says you have a 2006, this thread is in the 3rd gen section. Things may have changed over the years. Suggest you try the 1st gen section, people there may know your truck a lot better.

 

2006 is 2nd Gen.

 

(all in good fun, because this is the internet)

 

Yup, I'm only familiar with my stuff.

 

Look at the pic, I have a 3rd gen too!

 

Yup, it was a wire that pulled out. I just stripped it back slid on some heat shrink, dropped some solder into the plug and put some heat on the wire and it dropped back in. Heat shrinked it and good to go thanks!

 

a side note, i put a dab of hot glue where the wires go into the plug, i used electrical tape and wrapped it around the plastic plug a couple of times then continued wrapping down the wire a few inches so hopefully it will be harder to get pulled out in the future. I might do the same on the other side before it gets pulled too

 

I ended up making own, better than anything i could find already made. Extended them 14 inches