What Have You Done To Your 3rd Gen Today?

Glad you've got everything installed. I used the same mount except for the passenger side, same antenna too. I've got to sand or run a ground wire for my antenna, the SWR readings are too high. I'm reluctant to sand the mount due to living close to the ocean and rust. Oh well, I'll get it fixed soon.

 

WTF!!??!!

 

thanks Paul! I think I've gotten it to a ~decent~ stopping point, or at least that's what I keep telling myself

 

I think I would have moved to Idaho.

 

I agree.

 

The mount is stainless steel and I’m within a mile of the Pacific. After I sanded and mounted the antenna stud without a washer on the bottom half I was able to get the antenna dialed in. I also checked the entire antenna and found a slit which I covered with electrical tape. Any seepage of transmission will give you a high SWR reading.

Hope this helps. Keep us posted.

 

Close personal friends of the ruling class, multi-millionaires in their own right, were leaving the state to avoid the tax burden. Somrthing had to be done to keep the tax $$$.

 

What a crock of shit. Thieves.

 

Thank you! I knew someone must have had the same question. If not on the mesh, it would have to be in the middle of the windshield. Those buggers leave a mess when you remove them.
Edit: regarding sunpass transponder

 

I so much want to chime in on this but this is not the correct thread to comment.

 

For sure if I would have known I would have drove it for another 6 months . Thanks Brother loving the weather and area especially only being 2 miles from the beach. It’s definitely bitter sweet though that’s for sure.

 

My apologies and I didn’t mean to bring politics here just sharing my frustrations and what I actually did do with my Tacoma today.
Although not as enjoyable as it normally was

 

Couldn’t agree more and my exact thoughts as I pictured the girl behind the counter registering my truck with a bandanna around her face passing notes to me like a bank robber

 

Good old Michael Scott

 

Put the 4WP rock sliders in the garage because it’s too cold to do that shit today

 

How much lift are you running? Is there a required amount for these? Thanks!

 

Changed the cabin filter…it was time

 

Installed both of these this weekend.

 

Washed thoroughly, truck is white again not grey.