Hot Wheels

Front edge of the first plank rest on a nail in the wall right below it. Then the tongue of the next board goes into the groove of the first board then these clips that snap onto the rails slide down and into the groove to hold that one up. No nails. Just put the next board up and slide the clips in to hold it up.

 

The easy up tracks and clips made it easy. This is the clip that slides into the board. You can see there is already a clip in front of this one holding the board up.

 

Coming out nice but ran out of boards. Only thing I didn’t care for was you have to leave a 1/2 inch gap between the boards and the wall for expansion. Then put up some molding around the edges nailed into the wall not the ceiling

 

Looking good! So close to adding the cars!

 

Only lose 1 1/4 in the ceiling height. When I do the molding I’m going to just use 1” flat board.

 

Getting there! I have 3 floor display cases that I don’t think are going to make it in there. Need the wall space.

 

Perhaps you'll convince the wife to replace the bed with the floor display cases! Be like a museum with aisles! Hahaha

 

Trying. I don’t want the bed in there but she wants it for guests. It’s a queen size so lots of wall space behind it.

 

Chip Foose Design by Full Throttle. Not familiar with this brand.

 

Majorette Fun Buggy. Plastic is crushed a little.

 

65 Impala

 

Park Patrol

 

I’d be stooooked to see what you come up with on that

 

At first, I was thinking you where putting slots on the ceiling to hold and line your ceiling with packaged Hot Wheels.

 

Finally redeemed myself on the Mystery Model #3 Mercedes-Benz 300 SL

 

No but not a bad idea. I was thinking of using racetrack for the molding on the edge and putting cars on it.

 

Slot car track?

 

I was thinking just a single hot wheels orange track but a slot car track….. hmmm

 

I like this….almost too much but not at the same time.

 

Thank you again @AR15xAR10 for the trade!