3.4 motor won’t start

Hi my 3.4 engine won’t start but it cranks and I change my spark plugs and wires and my position crank sensor and I test my fuel pump it’s pump fuel. Any other suggestions

 

Do you have a scan tool? Did I just not start one morning? Was it running ruff then no start. Did you change these parts and then no start?

 

Does the check engine light illuminate?

 

The cel will with the key in the on position.

 

Did it run before you changed these parts or did you change them because of the no start?

 

I was driving home and as soon I reach home it turn off and I tried to start it and it didn’t start but it was cranking and I change all that parts after it did that

 

H808…….
Cut out 1hr of your time and search ‘hot no start condition’
Injectors and coolant temp sensor cured my issue
Many other solutions too

 

I scanned it and got a p1300 code

 

I don’t have spark from my coils packs and it is new coil packs and when I put my key to on the icm makes a clicking noise is it normal.

 

Rapid clicking noise is usually associated with a dead starter right?
Nvm forgot op said it cranks..