1st Gen Lunchtable Thread - General Discussion

Wow

 

@Kwikvette
@eon_blue
@JKO1998
I have everything for this. I'll report back later this week on how it works.
https://www.instagram.com/reel/C3K1R_kN1NN/?igsh=aDRnMmRrZ3I4aWN5

 

That for you or him. Hard to tell when you’re about the same size as him

 

Aren't you guys around the same size? Maybe Nelson will share.

 

new Diff has a MASSIVE leak from pinion seal

found an 8.4 full axle for $350 and a set of Chevy 63s for $175...

I need to scan the Spindle so I can judge if the BJ flip I want to do up front will work out or not.

 

DON'T

 

oh OK.

 

Gonna lock and regear the 8.4" instead now?

 

weld it

 

The... the pinion seal?

 

Im 5’11”, the doctor said i was a big boy.

 

Another inch and you could've been a man

 

I'm gonna replace the pinion seal since it will take 4-8 weeks before I can get to the 8.4. no wheeling in the meantime

I am pretty confused about the failure I experienced tho, almost like the heat treat was off on the pinion.

Looking back I built the diffs in January '21.

 

It can happen for sure, Yukon has had bad batches before, so has Nitro.... might get your new set cryo'd if you have the time.

 

Im 6’ with my boots on. Out here tricking everyone

 

gears are 6mo out of warranty

yeah it doesn't look like a hot wear pattern either.... ARB or Eaton for the 8.4, que debate

 

https://ksltv.com/629735/ai-could-pose-extinction-level-threat-to-humans-us-must-intervene-state-dept-commissioned-report-warns/?



Terminator otw

 

That sucks dude. I bought my 4.56 diff with an ARB in it already and so far it's been a good diff. I run it on a quality regulator and it has behaved. I don't like the engage/disengage on forward and reverse changes with the Harrop/Eaton, but I like the magnetic actuator. 6 of 1 half dozen of the other IMO

 

Good guy AI saving the planet finally.

 

leaning ARB