What Have You Done To Your 3rd Gen Today?

i used a small wooden roller for wallpaper, found at the box store, try to use whole sheets as much as you can, I think mine had grids on it, which helped on the layout. The bottom of the doors goes pretty quick, use some cardboard, like pizza box cardboard in areas you can’t see, making a template, then transfer over to the foil backing and cut it out..

 

Obviously you did the back of the door, sides and bottom. Did you also do behind the cross memebers of the door. Like the metal the door plastics pull off of?

 

Installed Baja Designs S2 flush mount lights to the Backwoods bumper. Had to enlarge the pre-cut holes on the bumper a bit, simple quick work.

 

Correct, only the outer skin, and speaker mounting flange, could not see doing anything between the interior plastic and door skin.

 

From "Damnation Alley". Looks close enough ...

 

Folks would claim they weren't good enough and change them anyway..........



.

 

I used to enjoy it too, until some hard working tax payers tried to steal my rig by ripping off my driver's side door handle and sticking a metal rod in the door to unlock it.....never been the same since

 

Looks like two dirty dogs in the wild.

 

Looks good. Do you have a link to where you purchased it?

 

double propane for this fella


one for the heater, one - for the stove and hot shower

 

Took advantage of the 75 deg weather today and gave it a well deserved bath.

 

Not today, but yesterday…



All of the speakers were replaced, too.

 

Paid in full.

 

BEST ... MOD ... EVER!

 

New, taller, jack stands arrived. My trusty old timey Craftsman units will be passed down to my spawn. Added more Ti to the suspension. Apache Off Road End Links are on the short list. :]

 

What a great feeling! Congrats!

 

Swapped on a new bedside, rear door, and taillights the other week