1st Gen Lunchtable Thread - General Discussion

How would you distribute the load on the roof? The pol would be a single concentration of load in one spot unless you spread it out. Not to mention your load would likely be on the edges of the canopy, although that depends on how you plant to mount and orientate the tent.

 

It’s made to have a roof rack, so it has 4 holes drilled into a thicker fiberglass section across the roof. So idea would be some sort of foot at the bolt holes and cross bars. Need to keep height as low as possible there

My concern is the shell sides bowing out, not sure if that is the right thing to be worried about though

 

I got the truck back. It drives a little wonky in FWD, but it should bout me some time at least.

 

Oh wow

 

Ignore the cloudy water; that's just the bacteria population having gone full bloom after last nights ammonia and bacteria introduction

This morning ammonia was at 0ppm meaning the bacteria ate it all; dosed it in ammonia again this morning to bring it up to 2ppm



Nitrites at 0ppm, but should steadily rise in the next day or two as ammonia drops



And nitrates I shouldn't expect to see until another week (more or less)

 

You need a driveshaft too?

 

Not at all, but I could've bought one with what I've put into all the new tools, tank, and plants

Post was meant in jest; aquariums aren't cheap but it's just the initial upfront cost that gets ya

Maintaining is cheap for freshwater; can't imagine the cost for long term maintenance is for saltwater

 

Definitely safe to assume my neighbor's moving out, he didn't even put out his garbage bins this morning so I pulled them out.

Wonder what's changed since he had mentioned wanting to buy the house later in the future.

 

I found this one from TrueDrive for under $400; does this not include everything like the RockAuto one?

 

I’d just get the joints changed and be done with it. Ujoints are super common and any shop should be able to knock them out without a fuss.

 

Lol that website is a disaster, the part cross reference is all wrong to the point that that CS reps don't even know what it fits. And the reviews are an aggregate of every shaft and part they sell not that one in particular. Might as well get a $250 ebay cheapo if you aren't gonna buy from a real brand.

 

What website did he even reference?

He's pretty good at pulling up Alibaba results that I can't even mimic.

 

https://www.carparts.com/driveshaft/truedrive/rt54550001

 

So at this point he's trying to save about $30-40 and risk a trainwreck versus buying what you guys suggested

 

my dented factory one is just fine

 

Seriously theres so many part outs up her for tacos, this is a part id just get used.

 

Could just go bluetooth once yours is destroyed; that's what most of the trucks at SEMA run anyway

 

@Wulf Did that computer and fans work out for ya?

 

ah I have been waiting on a display port adapter and NIC to show up from ebay, I haven't even booted it yet