Colorado B.S. Thread

Unfortunately, my internet is cell based. I need all the bars.

 

Who's your internet provider?

 

AT&T. They're not aware of it.

 

New plan.
https://www.tacomaworld.com/threads/bretts-06-tundra-camper-bumper-build.784540/#post-29755213

 

I'm so confused. Are you poaching off someone's hot spot?

 

lol, nope. It's an out of production AT&T device for your car so you can have Wi-Fi on the go.
Turns out it works great at home too. Streams movies just fine, just needs the cell signal.
Cost is $23 and some change each month, so I would prefer to keep it.

 

Any reason not to go with this kit?
@Squeaky Penguin

https://www.ebay.com/itm/385175661502?itmmeta=01HVCKDRGZDF70GP18MWT9ZE1H

 

Busy day today. Mom liked the watering can and requested a bigger one for herself.
Mother's Day is now covered.

 

I guess it's what was formerly Koyo, the parts should be good quality assuming the bearing isn't counterfeit

 

At least it's not from China. I'm primarily interested in just the tone ring and collar. Both parts can be purchased separately, but I feel it's best to have it all on hand in case there is another surprise.

That being said, I found my bearing splitter, and if I knock the studs out of the backing plate, I might just be able to get under the ring and just pull it up into position.
I always figure this shit out at the end of the day.

 

I'd send it.

Koyo is the factory bearing. The napa boxed one should be a koyo too if you wanted to pick it up right away and reuse the tone rings.

 

Were you able to press the tone ring and collar off as one unit?
I'll pull one side tomorrow and see if I can knock out the studs and get a bearing splitter under it.

 

No problem pressing it all out at once.

 

last question, how big is your press? Will a 10 ton do it?

 

Has anyone been to a Fever Candlelight event? We went tonight and it was a pianist and violinist doing Fleetwood Mac. It was pretty awesome.

 

My wife would be into the Tracy Chapman concert they do...

 

Talk to WeBoost (formerly Wilson Amplifiers). They can help you assess if they have a product suitable for your location

 

12ton.

I bet you'll be fine, especially since they were just installed.

Don't forget the circlip before you try pressing.

 

I'm just interested in getting the ring and collar in the right spot. With any luck I can just move it and not remove it.
I think the bearings are fine, they haven't been driven more than a few blocks so the grease shouldn't be diluted.
Thanks, appreciate the info. About to go and fire up the impact, welder, etc...

 

I thought the rubber duck thing was just a jeep thing? I just learned about it, though....