What Have You Done To Your 3rd Gen Today?

Have my windows tinted by pros from XPEL Canada. Ceramic, fronts at 35%, rears at 20%, which is over factory tint gives approx. 10%. Looking good to me,
hope it will reduce heat of upcoming summer.

 

Do the bump stops compress?

 

does the oem jack sit on it safely?

 

i underz standz pickters

 

new tacoma starter kit:
pro grill
raptor lights
sema wheels
gas hole
nipple clips
yoda sticker

 

not on mine

 

it stop squirrels too?

 

I have heard you try veeeeerrrrrry hard to master "See Dick and Jane Run With Spot". I commend your efforts.

 

thats my favorite, I'm on page 2

 

Looking good!

 

Been “working” on this for too long, almost done with the base. Next step to line up the frig slide. Main objective was no more holes (besides the tc bed stiffeners).

 

Busy last few days. Replaced a bent extension tube on my front diff after destroying 2x cv joints in one wheein trip (full details HERE). Installed a 55w solar panel on the top of my pelican case. It fits perfect and besides the wire housing, you wouldn't even notice it. I didn't want to sacrifice any space on my racks to just solar so I figured, find one that fits on top and as a bonus I can open the case and angle it towards the sun, using the OE hinge on the case. Eventually, I will add a second, if I find I need it. I also added the cascadia 4x4 MPPT charge controller on the lid of my fuse cover and hooked up to the battery. I also ran the acc wires through the firewall to the back seat with an anderson plug end, so the solar will charge my Jackery 1000 that runs my fridge. I got my DMOS mounted to my tire, my 270 awning installed back on my rack after powder coat, installed scene pods on that rack and mounted up a 4 gal yakima road shower. I will use the air lines I plumbed to all 4 corners and the tailgate to pressurize the tank for a hot shower after a day on the trails or to run the mister system I whipped up. I packed all my gear, reorganized the drawers and cases up top and I'm headed to Moab on tuesday!

 

I’ve had my RC seat covers for about 3 years or so and they are holding up great. No signs of wear and they fit great. Happy with my purchase and a great value. ($200 for front and rear seats)

 

why dont you go to a farm store and by a stall mat and cut tit o fit the bed.

 

Absolutley durable. You really need to tug and yank on them to get them into position. Surprised at how strong the thread is.

 

you know it may need that again, it was done post lift by Toyota and post wheel/tire install, but as weve discovered, they did a piss poor job so... might need to run back to Discount Tire..
thx

 

wow thx for this. could certainly be this.

 

not today, but over the weekend: pulled the transmission pan, replaced the filter, broke 1 bolt 4 drill bits, and an ez-out. I hope whatever dumbass that elected to use the cheapest M6 screws possible to attach the transmission pan bursts into flames the next time they are taking a dump.

PSA: the bolts are M6x1x25mm, I replaced the broken one with a class 10.9 flanged head, all of them got anti-seize before re-assembly.