Upgrading an unknown suspension and removing lift blocks

Hi,
I recently bought a used 2007 Tacoma 2.7l 5speed. I plan on taking it off road and occasionally hauling some loads. It has some unknown icon and Old man emu suspension parts.

The rear leafs were replaced a few years ago / 40k miles ago and there are 2" aluminum lift blocks in that I'd like to upgrade.)

I am a "buy once cry once" type of guy so I'm wondering what lead pack to get that will maintain this 2" lift in the back to keep the overall stance of the truck the same .(I'm reading that AAL will lose lift / settle over time, so I think I should avoid that.)

 

Also what driveline modifications do I need to do to keep the alignment correct for the driveshaft/ diff etc.

No install video I watched mentions such.

 

Dobinsons.


You're welcome.

Talk to @Crikeymike.

 

The part # on the pictured leaf pack looks like a factory replacement. From there I would figure out the shock and if a replacement front set of springs were installed. Then it shouldn’t be to bad to duplicate a kit to replace. I added an AAL to mine, 887’s up front with 5100 shocks on all corners and love it more than stock. Towing and hauling has been fine.

 

But since the lift block is 2" tall I know that I need a leaf pack that gives a 2" lift, right?

 

If that’s what it is. You have good stuff and if your replacing most then you and outfit it the way you want. Just find out what springs you have up front. Already got good control arms.