N2 Design Remote Start (Push start)/Module doesn’t start

Hello everybody I installed N2 Designe remote start on my 2016 Tacoma TRD of Road with push start key. I installed the remote start and followed directions and YouTube video from N2 and worked fine, at first. Was able to start with key fob, tested it 3-5 times no issues started right up. A couple of days later I tried it and was unable to start, the sequence stops right before the starter kicks in (Started does not prank). I tried reprogramming and still nothing, I completely removed & reinstalled everything and no luck (everything is connected securely, all pins in good condition). I noticed after I try to start the truck my dash, fog and a few other lights started to flash for a few seconds. First 1 times then 5 consecutive times. I can’t still turn it on just fine and I’ll starts right up and drives. Any advice? Thanks in advance.

 

I contact N2 Designe waiting on a response from them

 

why do you need a remote start?

 

I live in South Florida and have 2 toddlers we use the truck a a family vehicle with the remote start the truck will be cooler by the time I sit them in the car seat. I have a 12 V solution in my wife’s Camry. Having a not steaming hot car to put the kids in it’s amazing

 

ok....the tacomas are sensitive to electrical add ons

 

what do you mean exactly

 

when non oem things are added sometimes it causes electrical problems

 

If installed wrong...
95% of this forum has some sort of electrical addition added with no issues.

 

that’s why we are here to try and figure out what happened when things go wrong or to show how it was done when everything went right