1st Gen Lunchtable Thread - General Discussion

Did you make it home? How long did it take.

 

could have been worse, could have crashed landed on an island fighting for survival for several years only to figure out we were really dead all along in the end

 

2 hours on the runway then finally got to take off, missed our connection but luckily got the last few seats on another flight home a couple hours later. Really not that bad but just been a long ass day, and with two little kids, particularly a toddler running on fumes and blind rage the stress just compounds exponentially

 

Can only imagine; I'm only at the beginning of the toddler stage

 

Sorry your plane had issues, it must've been all those parts I took off of it.

 

How many Boeing doors do you have?

 

Not enough

when one door closes, another one opens

 

R33 pulled over; always hated how the rear reminds me of an 05 Impala

 

Saving the world, one modified exhaust at a time...

 

@Kwikvette you got any prawns yet

https://www.instagram.com/reel/C5mZ6QaPKhR/?igsh=MzRlODBiNWFlZA==

 

Wtf

 

@time623





Personally I think 11 gauge would work really well; it's thicker than my bottle openers I typically make (12 gauge) but small enough to be really strong and stiff

With that said I made this out of 3/16" and seeing how I don't have any mexican coke, and my beer is all canned, I can't test my opener so you'll need to be my tester

 

Made a few extra in case someone needs one, each out of 3/16"

 

Just put those on the the bottom of my light brackets

 

You haven't even confirmed if the piece I sent you works, and I gave you a one day turn around even

 

I mean they match them up with the bottom of the bracket, close enough.

I was gonna send you one of the rubber insulators to make it match perfect. Maybe I'll do that Friday.

 

One well in the middle of no where, 6310 BBL or 265k gallons for all its shit


And the ferd

 

You got my address, send it over when you can

 

The shop luckily doesn’t have any time into my truck, so I can just have it towed back to my place tomorrow.

On the 3.4, do you have to drain coolant and remove the upper hose and/or radiator to change belts and the fan support bracket?

It seemed like there was plenty of space to work with then installed, but I wanted to make sure..

 

The fan and clutch being uninstalled leaves tons of room

Then when those two go on, there's still room to do so with the radiator in place

You're good