What Have You Done To Your 3rd Gen Today?

Looks like Tandem 612s. Do you know which version those were? They had a recall and replaced a bunch of the early ones at some point.

 

Whenever I've been attacked by a deer the insurance called it an act of nature and covered all costs with no deductible needed or history (supposedly) on my file.

 

SnoopisTDI is correct- Tandem Offroad 612s. I don’t see them listed on their website anymore. Haven’t weighed it recently, but it feels heavy lol. Running duratrac load range D. I’ve run these for the past 4 years and over 70k (with the camper installed for more than half of that) and have beat them up pretty good. Never gave me an issue until now. Not really upset at the manufacturer, could easily have been my doing from ‘off road lead foot’. I never received any communication about a recall, so idk if that would apply to me.

 

Thats wild for both situations! glad the back wheel didnt cause any worse damage!


I mean the front aint terrible considering, could throw some JDM hood/bumper fasteners on that side and call it good......but then again i'm unaware of your insurance situation etc. glad you and the truck are okay!

 

@piotr1aj Looks like the bike didn't budge? 1Up racks are solid. Unfortunate about the wheel. Hit me up if you need a set. I'll give you 50% off

 

Finally cranked up the the coilovers. It's been sitting too low in the front since the install last winter. Removed the vinyl from the B Pillar as well.

Before


Now

 

Yea the 1up rack is super solid. Highly recommend. I’ve dragged it over rocks and backed it into dirt mounds. Only has some minor scuffs.

Appreciate the offer, I’ll keep that in mind!

 

Ran speaker wires, amp wires and washed inside and outside of the truck. Sucessful morning. Just waiting for my box and amp rack to come in

 

Sherpa mid-height bed rack

 

Truck looks awesome! Seriously a nice looking machine! Who is that bumper made by? I haven’t seen one like that before.

 

Thank you sir!! Bumper is from Outgear Solutions

 

No more chrome BumperShellz.
20 min install

 

Rad

 

Today I installed an ARB differential Breather kit

 

Decided to go with the aluminum OEM running boards instead of the D1 rhinos because I got a very good deal on them. Unpacked the hardware and laid it down only to realize they gave me the tube

 

damn that is WILD!!! Gald that rim blowout didn't cause any accident - sheesh!!

 

could run such a breather into the air box, if one didn't care about the under hood product placement banner.

 

there are many different ways to do it...some run it behind the rear light, some run it to the gas cap, some run it into their bed.

I wanted it under the hood in case I need to run more hoses to it down the road.

 

Exchange them?

https://www.youtube.com/watch?v=02C3inivh-A

 

Where did you get the panel with the auxbeam cutout?