What Have You Done To Your 3rd Gen Today?

Right on. Thanks!

Just realized how hilarius this "see post" response was. LOL

 

Looks great. Mine came with the factory rack but I prefer what you did. By the way I could tell from your photos that you were in Calgary before even looking at your info. The trash containers and the look of the neighborhood is typical Calgary. Some towns have a personality of their own.

 

Man I was really into into this as I have it in my camper shell. Looks slick are you going with a fairing? I would of gone with it also but was the same price as a bolt on

 

Goose Gear’d my back seat…

 

I'm trying to see if I can cut down on the dust that makes it into my bed. I 3d printed some little caps for the bed cubby, super glued them on, then put a bead/glob of silicone around them.

Caps



Bottom



Top

 

The photo appears to have melted, did it? Did the engine oil get hot enough to melt it, or did something else get close and hot enough? Can you elaborate on how it failed? (What caused the hole?)

 

What springs did you go with? Stock height or lift?

 

It looked as if it was cracking at my last oil change, so I went ahead and ordered the metal housing. Although it looks melted, that's just the point where it finally failed. I noticed a small oil drip onto my skid plate, and at that point it had cracked. Upon removal the tab cracked the rest of the way.

 

Measured right after install, they were 2.5" above stock, probably settle to about 2".

 

https://ironman4x4america.com/suspe...pring-kit-suited-for-2005-2023-toyota-tacoma/

Those are the medium load option

 

@Shmellmopwho set me up with some 20° top plated rock sliders. Stoked on them. Ironryno fabrication.

 

Thanks for the replies! I like the mil wrap on the ends.

 

The best tools grip the housing at the full-base, where strongest (but where the crack occurred anyway). Some use a tool on the sides where the stresses can exceed the design of the plastic.

I am not sure what you or others used, but if not something like the Motivx tool, it might have been damaged.

 

Thanks, I forgot to paste the URL.

 

Thanks, Don't really need fairing piece, because of not a lot of use day by day;
Yes, it's pricey, but I also have purchased different set of hardware and can use it also on
my wife's Mazda.

 

Threw on a set of 265/75r16 KO2s. They feel great on the road, I like the change from the OEM Kevlars so far.

 

Mine had been over-torqued from the dealership's 2 oil changes included in Toyota Care.

I do my own oil changes now and find the OEM Aluminum Housing a sturdier choice.

 

you use an impact?

 

you are a wild man

 

Toyota Oil Filter Cap -

$38 15620-31060 15643-31050

15620-31060
Ordered from Amazon and installed in Sep 2018 on my 2018 Taco. When I went to my purchases just now to look up/confirm, the page indeed now says, “This does not fit 2018 Tacoma”. Well, somebody needs to tell that to the part that’s been on there for almost 6 years…..