35x10.50x17 Kenda Klever R/T Kr601 Thread *SKINNY 35s*

Great set up man. Got the same wheels and tires but with a 1.25" spacer added. No rubbing now that I trimmed up the fenders.

 

I’ll ship on buyer’s dime.

 

https://www.ebay.com/itm/3055300654...hydzl4607OcGvwvYmNeSymbbyMARz9_hoCIMQQAvD_BwE

 

So I ran into a guy today, apparently Kenda Klever RT2 is 7-9 months out.

 

I wonder if they got their snow rating this round.

 

They definitely don’t suck in the snow as is.

 

I just hope they weigh less.

 

With out reading all 29 pages what is the real measurement for the 35x10.50x17?

 

This and I hope they make a 285/75/16 this go around.

 

30psi With weight on it, 40% tread. Probably just over 34” new without weight, middle of the pack for a 35 I would say.

 

You run these at 30psi? Jeebus. How much weight you have?

 

I run them at 40, lol.

Might explain the cupping now that I think about it.

 

Uh, ya
Lol

 

Front yea. Rear I had at 28 ish. On a double cab first gen, bumpers, winch, skid, sliders, sometimes tent but not much else.

 

I’m really wanting to try these always been a bfg km3 fan. How’s the ride and wear on these? Do they perform well in mud and snow

 

Got the skinny 35s on the trail whale.

Flex testing


Clearing the fender flares

DIY CMC I’d did last weekend
Looks like I need to tub the front inner fenders a bit.

Fit the skinny 35 spare under the bed in stock location with a few modifications

 

Looks great! How did you get the spare to fit? Did it simply mount in stock location or did you have to modify it a bit?

 

I moved the hoist back so the front bolts are using the rear holes and drilled new holes for the rear. Hammered the alignment arm an the driver side upwards some and the passenger side all the way flush with the crossmember. Deflated the tire to 0 psi and cranked it up while pulling back on it. It is snug against the shackle hangers but it fits.

 

FYI I just measured my new tires at 33.75" at 38 psi mounted on a 7.5" wide wheel with the weight of the truck.

 

Hi all,
First post here. Recently joined the skinny 35 club, really liking them so far.

Edit: I guess I should mention for those interested, wheels are KMC 725’s 17x8.5, 0 offset. I’ve done a CMC, flattened the pinch weld and cut/tucked the liners underneath. Very minor rubbing occasionally in reverse but nothing notable. Also still on stock 4.30 gears and I haven’t been able to notice much of a difference from the 285’s I came from which is nice. This was kind of an experiment and I was anticipating burning up my CC on the ECGS site right off the bat and going 5.29. Will eventually re-gear but for now this is totally fine.