1st Gen Lunchtable Thread - General Discussion

There are two other members that do that often in the 1st Gen section

I thought it was just a critter thing, but it seems to be popular with boomers in general

Wonder why

 

no I just had to move them out of the way of the timing cover. I suppose I could’ve pulled one loose by mistake. I’ll take a closer look when I get home

 

One of my favourite opening scenes to a movie ever
https://youtu.be/lcLJj6i1LTs?si=-ueGLxHJW3dVrSwE

 

Maybe disconnect and reconnect that cam position sensor connector we had you look at too

 

Is this supposed to be connected to something? Can't remember if I have a loose connector there too..

 

my team is pretty good about keeping meetings between 9-5pm but today I had to meet with a customer so it was a very early morning lol

 

I was gunna see if you can just the controller maybe or get a set of their wire schematics

 

Meh, ordered one should have all I need besides an air drier and a box, plug it into one of our solar packages at work to see if it works.

 

If these will be left out for awhile, just get a simple self-draining water separator and attach a vinyl tube to the end of it leading towards the ground outside

 

I'm worried about freezing

 

holy shit that was awesome haha. How have I not heard of this, going to have to watch that tonight

 

Ok then don't run any filtering at all

 

if there's enough water that your filter/dryer is freezing solid you're probably already fucked lol

 

Put on a coat?

 

Exactly

Any filtering in general, will capture moisture which can cause a freezing issue

I was more or less specifying what type of drier he should use, especially if these systems will be out and about everywhere

Using a paper filter type, or even a desiccant setup, will require the end user to replace/replenish said media

An auto draining water separator is basically set it and forget it

 

Water collecting in the tank

Gotta have something, they get water in them for sure

 

No shit

 

Frozen tank is no good

 

Package it so the drier is near to the pumps which generate considerable heat in use

 

Absolutely not, read my reply above!

Cause if I recall correctly, this will be a prototype to something you wish to build but you'll require a shit ton of them

I don't think you want to go on an expedition replacing the media in each and every single one of them