What Have You Done To Your 3rd Gen Today?

kinda of a small shopping mall with 80 gas pumps

 

wtf x 2

 

As long as people are not on welfare roll ... not my business.

 

guns and knives hold their value

 

300 ft

 

Just bought a couple Kershaws for $37 each. (I know they aren’t the cats ass). But I just bought an old cast iron Dutch oven for waaaaaaay to much money.

 

Is that wheel any smaller in diameter?

 

Looks amazing. I need to go check them out. I’m local to them.

 

NO, those lose value, like most anything else

 

They gotta be gold knives.

 

yes, & historically documented demon slayers haha

 

Factoring Inflation, depreciation, appreciation and the "state of the economy",

It's hard to go wrong with a rack full of certified 4130 seamless tubing.! ;-)

 

not the ones i buy

 

$500 ..... Mini Infidel

 

The power cables through the rear window is a nice touch. When you see random vehicles like this on the road, do you ever think to yourself "I wonder what their house looks like."

 

Same one I have, I love it.

 

Those look sharp. No backlight, but I don't do much night driving anyway.

 

very nice!

 

Installed the Anderson Engineering intake spacer yesterday. It took about 90 minutes from opening the toolbox to finishing putting the tools away. One tip I'd offer (especially if your truck is lifted) is letting the air out of the front tires to make it easier to reach everything under the hood. I can definitely feel that the hp and torque have been shifted lower in the rpm range right off idle. Drove the truck an hour to work today and some smaller hills that used to cause the truck to lose speed to the point it would downshift now cause it to only lose enough speed that it can "recover" by just unlocking the torque convertor. Unfortunately I forgot to see what the trip average mpg was when I got out to see if it improved at all over what I normally get. I'm looking forward to seeing how it does towing the boat or quad or even how it does hauling the snowmobile in the bed.

 

You should see the cover now it is getting worse and I'm trying to figure out how to fix it and obviously my wife cant help me with it, so its a one man repair job, i have to figure out how to get the rubber gasket up top off so i can try and use this special 3m adhesive that is both temperature resistant and heat and moisture resistant and apply it to both the aluminum and the material and stick it together like contact cement, but i cant use a heat gun near that product. and you need a respirator to work with it.
I will constantly not recommend this cover to anyone, i should of purchased the diamond back cover all along.