Show Off Your Steel Wheels

16x8 rough county steel wheels fit without any spacers whatsoever. Have 33 9.50 16 tsl sx2 tires mounted on them with no issues

 

As an olde school reference, here are some pix of the Hiluxes used at Helsinki's airport 8-10 years ago.

 

Says it right in the post you quoted: "16x8 Rough Country" wheels.

But to answer the other part, no GM wheels will not fit...the center bore hole of a GM wheel is typically like 78mm, when Tacomas need 106mm

 

There only 16 x 8 w/ -12mm offset . steel. Rough Country

 

your talking about two different post the one I quoted is completely different.

 

Update pics — made a couple changes!

 

These are the steelies on my 07 Corolla. I sanded them steel wooled them and gave them an alcohol bath before 2 primer coats and then bronze. I touch them up every 2 years or so before a rotate and balance, removing weights and a quick sanding with 180 grit. They definitely get chipped and dull from the salt and pebbles from the winters here in Michigan. I thoroughly cover my tires with blue painters tape. I get a lot of compliments on them. This pic was not taken after a touch up. I asked the tire guys to put the weights back where they took them off because it usually takes the paint sometimes they don’t listen.
If your daily driving with them on or playing hard you definitely will get to see what’s going on underneath that topcoat.

 

Picked up a set of 17x7.5 at the not so local dealer for $100 w/ nuts,
Found a set of old caps on eBay for $50,
Probably gonna shoot them white and try to find some good used white letter KO2 for winter and put the Beads away. Wish my old 15x6 FJ60 wheels would clear the calipers. 1/4”Spacers?

 

Installed two days ago! Found the factory 2nd gen steelies on Craigslist, $75 for four of them. Mounted them on 255/85R16 Falken Wildpeak AT4W’s and got one for my spare.

 

Nice man good looking!! Gonna switch to this tire size when my suspension gets old and I do a 2” lift.

 

From everything I’ve read you should be able to fit this tire size on factory offset wheels with no lift and no trimming in some cases.

 

Were are you finding these?

 

I bought mine from Stealth Custom Series, but I’m sure your local tire shop has them.

 

Hi All! First post here and am new to Tacoma’s. Thinking of swapping to steelies and am wondering if anyone has tried these wheels?
https://www.ebay.com/itm/175867709035
They are 16x7 with a 5mm offset. Bore and bolt pattern are all Toyota.

Thx in advance!

 

All the specs check out. Be advised they will not accept center caps, and need acorn nuts

 

I’m sure liking these winter wheels, they look better and better the dirtier they get!

 

I like those better than the SR steelies I run on mine in the winter.

 

Sweet color combo! I’m also digging the RWL

 

Where is that center cap from?