What Have You Done To Your 4th Gen Today?

Painted the rear portion of exhaust to blend with the exhaust tip, and satisfy my OCD.

 

Iron x, clay bar, collinite 476 wax

 

Installed lasfit switch backs, will install matte screen protector and window decal tomorrow. Also I apparently drunk ordered a dump tail pipe last night...

 

Nice looking rig

 

Due to a limited budget, purchased a low-cost hard tonneau. It works. I haven't had enough rain for a watertight test, however I travel with waterproof storage boxes, so this isn't as big of a concern.

 

Looked under the hood and found a lable affixed to a wire harness that indicated Mfg build date Oct 2024. Wonder why???

 

Its UPdated

 

Hah, I was checking the oil in mine last weekend and saw the same thing. Thought I the vape pen hit too hard, but I guess not

 

What a pain in the ass it is to install coilovers on these new trucks. Front is done though, thankfully. Rear shocks and bumps going on in a day or two. I may need to lower the front a skosh, raked out right now.




Hella drooooop

 

Worth it! You'll be turning heads with this showstopper!

 

Thank you!!

 

Installed the @Diode Dynamics hitch light. I bought the non brake light version. I will report back on brightness tomorrow but if I am being honest for the premium price it misses the mark. The casing that the light comes in I am sure is a generic one and certainly does not work great with the Toyota oversized receiver hitches. You can see from the pics if I set it to where the actual tabs lock in to the side holes it sticks out quite a bit and looks ugly. It also wiggles a ton in that position. I had to just push it in to make it flush and it is fairly snug so I hope it stays that way. I mean $25 on Ebay I would have been completely fine. At $106 I am just meh on it.

 

I installed the VLEDS license plate reverse light. Very good quality, perfect fit and reverse lights are way brighter than stock. Expensive but well worth it.

 

That trim piece around the plate is awesome. Looks like a dog tag silencer. Can't say I have ever seen or notice one before.

 

Put on 8" Billiebars, fit and finish were excellent but those aluminum t-nuts catch on everything in the rails.

 

Just a rubber one off Amazon.
ASIN = B0829XLPPY
Currently unavailable it says.

 

Thanks. I found some like yours in a 2 pack. Will add it when my plates come in and give the wife the other.

 

Perfect fit!

$14 Zhizhong Rear Middle Window Decal Compatible with 2024 2025 Toyota Tacoma, American Flag Back Center Sliding Window Glass Vinyl Sticker

https://www.amazon.com/dp/B0D4QFSBK1?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1