2nd Gen 4.0L V6 Tacoma fabricated solid motor mounts for sale

@Bonzen I'm going to be traveling for a few weeks. Assuming my mounts have not shipped yet, could you hold shipping them until like the 26th?

 

I got the bolts out with a big pipe and socket wrench. the bolts on the driver side were a little rusty and seized a bit

 

If you are the Vancouver, WA address, yours are being welded up now. I can ship them to the next TW member and build yours next week, and hold until you say to ship.

 

Yea that's me. That would be fine, i'll ping you when I get back.

 

got them all in. Spec u headers was an obstacle so I removed them.

 

Those support brackets are helpful at preventing cracks in the primary tubes. Cause by the bouncing of the exhaust. That mainly depends on how hard you are off road though.

In my experience, the mounting holes need to be notched to create a properly snug fit onto the Spec-U headers, or even other brands.

 

One last GB kit to ship and its completed with the paint drying. Some of these colors take extra days to dry, IDK why but I'm thinking its the humidity down here is southwest AZ.

Guys, please ship me the passenger side engine block brackets after you do the install, instructions are included with your kits and highlighted in green

 

Does anyone have the fsm procedure or link on how to R/R this on a 2nd gen prerunner?

 

unsure about FSM but jack under engine, losen bolts, lift up. remove mounts. then do one side then the other. I believe drivers side is easier to start with, then passenger.

 

One last one, but it will ship soon.

@stickyTaco - Shipped
@Murphinator - Shipped
@PhoS - Pending Shipment (Ready to ship)
@wrmathis - Shipped
@GilbertOz - Shipped
@BenMara - Shipped
@chueflee - Shipped
@SUMOTNK - Shipped
@sf.larry - Shipped
@findingthingsout - Shipped
@zerotimeouts - Shipped
@TheFang - Shipped

 

Use wood or something similar, to distribute the load under the engine.

 

Yes good call. I assumed that would be obvious

 

Got mine already!!

 

You never know. Lol.

 

I include R&R instructions with each kit

 

The last kit is sitting on my kitchen table under the AC vent because it was still tacky last night in the shop.

 

Pass side block bracket that I will pay you guys $40 for when you ship it back. This is all I need. Instructions are included with all the kits.

 

I'll gladly send mine back for $40 as it would otherwise end up in the trash. Just curious what you want it for?