2008 tacoma front impact harness

The wires pulled out of the harness now my airbag light is on.

Two wires- green/white wire and a brown wire

Can i put these back in the harness and if so which goes on which side

 

Disconnect the negative (black) cable from your battery before you attempt to reconnect anything, but especially anything to do with airbag/SRS system.

 

Do you know which side the green/white goes and which side brown goes

This isnt it but to use as reference which wire would the green/white wire connect to?

 

I don't know.

Wait for someone who is experienced with this system to answer. Maybe @Dm93 ?

 

Yes, @Dm93 should be along shortly. He is an absolute gem in this forum. He is our best bet here. Hang tight....

 

Pin 1 (Brown)
Pin 2 (White/Green)

I would recommend soldering and heat shrinking the wires with marine grade heatshrink, SRS circuits are very sensitive to any added resistance to the circuit. Next best thing would be a heat seal butt connector properly crimped and sealed.

 

So using my photo is this saying green/white would connect to white wire?

 

Should be but verify on the connector, majority of Toyota connectors have the pin numbers stamped into them on the wire end.

 

No numbers on the connector

 

Driver side impact i have a green/white wire and brown wire that got pulled out

best way to fix i have wires taped off and zip tied up

 

PIN numbers on most connectors is on the back, where the wires go into the plastic.

 

Here it is

 

In your photo, I see a 1 on the right and 2 on the left.

 

I dont see any numbers

Are you saying this?

 

Took me a bit to see it.

 

That is some good eyes i see them
Now Thank you

 

Yes I was, but now you see the light

 

Can i just reinsert these, seal, plug in?

when air bad light automatically go off or does it have to be reset?

 

Okay i took it to someone who knew what they were doing

they pulled prongs out of clip and reattached the wires and reinstalled. Now no light