What Have You Done To Your 2nd Gen Tacoma Today?

Your light setup is so sick! Do you do a lot of night wheeling? I try to avoid wheeling at night but did so the other day and my minimal amount of Lights definitely came in handy. I bet you're set up turns night into day

 

Those are BaDass.

 

I installed an LED Toyota badge that I had gotten on ebay for like $23

 

Not at all, no issues at all.

The halos inside the shroud are Profile Prism and the ones on the exterior of the shrouds are Diode Dynamics 80mm halos. The shrouds came pre installed with the switchback halos on the back.

Thanks man!

I don’t actually lol…it is literally like daylight when I do use them.

Thanks man!

 

Tag lights were trash so I took a chance with some from Temu and they are bright!

 

Did you use the one at the beginning of the post from the OP or the one in the last two posts in the thread? If you did the latter, how did you tap that connector EB1 or EA1?

 

Nothing exciting, just a little psst psst remanufactured exhaust tip a la Rustoleum High Heat.

 

I did the one in the first post. I'm still trying to decide if I want to do the one in the last two posts or maybe go another route.

 

Fender trim complete. Only cut about 1.5”

 

Beefy

 

Tire size?

 

Maxxis Razr AT 35x11.50R17

 

Touch-up on wool wax undercoating.

 

Gave her a wash so she’s presentable at the beach next week.

 

Quick question,
Getting a little clunk taking off from a stop and I'm going to jack the rear up and check the rear driveline. Might as well hit the U joints up with grease while I'm there, BUT, the manual calls for molybdenum disulfide based.
What is the general concensus of what to use? Internet search shows most with moly are lithium based.

 

Not sure what the "official" grease is, but use this for my joints

 

X2

 

X3

 

X3

 

Took apart the interior
Cleaned it
Installed butyl over everything (overkill)
Installed thermal barrier over everything
Installed OEM vinyl floor
Happiness

Still need to reinstall the interior