1st Gen Lunchtable Thread - General Discussion

I called the dealership on the rack (it may help that my stepdad worked there for many years) and they are going to exchange the parts for me so I won't be rebuilding the rack after all. I will have to go pick it up in person for the exchange but the gas money and 8 hour trip is worth not having to eat the $450.

 

Damn your closest dealer is that far away?

Or are you coming down to the phx dealer you ordered from

 

8 hours round trip to Larry Miller in Murray UT. The closest would be Steven Wade in St George but I haven't had much luck in my past dealings with them even when my brother was working their. They also don't have an online parts store and they don't offer delivery. I've been able to get them to ship parts for larger orders to the local Napa in the past but it was like pulling teeth just to get that plus it gets sketchy dealing with 18 different middle men

 

Cedar City is on a lonely stretch of highway, I remember going through on my way back home from Montana once. Beaver was a good laugh tho

 

I bought an I <3 Beaver mug at a gas station there on the way to the Moab trip

 

O I thought it was the Larry Miller in phx

 

Larry H Miller dealer group stores are all over, their whole schtick is they buy failing dealerships

 

Bolt kit arrived!

Man, was a bit of a work out constantly bending over and adjusting the leveling feet to square and level it all out

 

looks awesome, I'm jelly!!

 

Needs more cow bell

 

I need a bigger CNC table

 

I thought you needed one that cut squarely

 

Oh I always desired a bigger table!

But you are correct sir

Even Hypertherm can't figure it out.

 

I'm sure you've done this already... but have you taken the consumables off and purged the air line entirely. Just wonder if a little bit of something was in to causing the air to dogleg

 

STV Sparx Pro

Fully welded setup, 3:1 gear reduction for accuracy of .002" per 12" and more

 

two thou over 12"... what kinda hack approved that. call me when it can hold 2 tenthousandths over 12"

 

I did, but not to intentionally purge the line but to ensure psi did not fluctuate with or without consumables installed; Hypertherm asked for me to do that

I do always purge the line though before cutting the way you'd hold your MIG gun and let gas run through it before welding

 

Inspected the consumables for imperfections and caught bullshit?