1st Gen Lunchtable Thread - General Discussion

Lol sorry, I've been to Kentucky... it seemed nice enough, but it also gave me 0 reasons to return.

 

its ok lol.

and its ok.

I would definitely rather live somewhere else, but it is not miserable

 

It's how everyone else in the US sees anyone living in CA

Assume none of us lived anywhere else

 

Well, did a super quick test cut.



More than 3 degrees of bevel still exists



The remaining edges have less than that, but because it seems pretty equal between the 3 edges makes me hope that once I adjust the height, I'll get 3 square edges and only the top edge with less than 3 degrees.

 

Still though, living elsewhere and deciding CA was the magic answer all on your own is worthy of a little ridicule.

 

"Way of the road"

Fucking classic.

 

Still looks better than Trail Gear parts

 

Oh absolutely

It's more like "of all the places I lived...CA is way better than IN, SC, TX GA, AZ...."

Germany was nice AF though

 

that looks decent enough to me too, but I'm not out here trying to sell stuff

 

Their cut parts can't be that bad......

 

We get some laser cutting done at work, same problems even on 7 figure lasers lol

 

I'm not saying it is, just that plasma parts from most places are low tolerance anyway... the process isn't laser level accurate. Why not make this ADHD rabbit hole even deeper and integrate an A axis for torch angularity control, then you can compensate and cut even larger bevels on purpose.

 

That suuuucks

If I was using laser cut parts as a reference, then yeah plasma cutting could absolutely disappoint (generally speaking)

But a $700 plasma cutter does this -









Maybe I should just listen to y'all and accept the results cause everyone is saying it's acceptable (except me)

 

tracking is live for Rebelle, I'm stoked. They didn't quarantine phones yet... and Apparently my Wife has an issue with ODO calibration and I can do nothing but cheer lol

 

I just think you'll be chasing your tail forever, you had a really good initial setup... one that was likely an exception to the rule really. Your parts were near laser quality minus the slag and dross. But usually that isn't the case with plasma cut parts, they're way more prone to beam deflection.

 

You're right, I just gotta rip the band aid since there's nothing to fix

 

Keep working and let me know when you can start cutting 1 mil wide parts square and I've got a contract for you lol

 

That looks like shit. Do better.

 

The whole 100 series talk had me all fucked up

 

One of you guys should tag him if he bought his new rig

I'm sure he put me on ignore