Clutch release bearing sleve

Can you buy and replace justnthe sleeve mine was completely gone when.took.apart to.put.new clutch in

 

It would be helpful if you were able to post a pic.

Unfortunately the quill (snout) on the V6 is cast into the bell housing. If your quill is all marred up but still intact you could get the quill kit and place over it. If you are interested I can dig up the order details, but I would still like to see a picture...

 

Oh, and welcome to the forum.

This is the actual manufacturer of these kits. They are located north of Denver.
https://www.pdmusa.com/OrderStorm-ecommerce-product-page/759177DA-A48A-4243-864E-DD688AD9D625

 

Probably tilton kit talked about on here

 

Unfortunately I don't have a picture but i can tell you the quill sle e was. Completely gone

 

Does anybody have good or bad to say about this especially over the hydrolic kits?

 

In URD's own words:

https://www.tacomaworld.com/threads/black-magic-of-the-clutch-release-system.461759/