AZ Classifieds

Arr these internally crossed over?

 

I feel they're too shrill.

 

Yup. Although I ran the tweeters through the stock wiring.

 

Total Chaos uniballs that have 2 weeks of street driving usage. One has an indent after being pressed into the control arm that was damaged by previous owner as control arms were purchased used. Damage was discovered after removing trashed uniball and truck was needed for daily driving so it had to be pressed in unfortunately. These were pressed in using Total Chaos uniball press tool and went in smoothly without being forced. $150 for uniballs.




Bushings and washers for Total Chaos control arms that are 6 months old $45






I do still have the control arms if someone wants to purchase them and try to fix the damage caused by the previous owner. Only the drivers side has damage that I could find. I assume no liability for harm or damage caused by any fixing or utilizing of control arms. Can negotiate a price. These fit 2nd and 3rd gen Tacomas, FJ Cruisers, 4th and 5th gen 4Runners, Gx460, Gx470




Misalignment spacers and bolts for controls arms $80

 

Posting up some of my mods from my 2nd gen for sale/trade

Pakrax angles sliders for 2005-2023 DCSB - $700 or trade for non-angled sliders





Frontrunner Slimline II roof rack with ratcheting shovel mounts, awning mountd, rotopax mounts, and wind fairing - $750 or trade for prinsu/prinsu style rack



Wildtop Topper, comes with my DIY "north/south" rails as well as the normal crossbars - $850





Thule Tepui Low Pro RTT, comes with rainfly - $800



Backwoods Adventure Mods skid plate set (IFS, trans, transfer case) - $400 or trade for TRD Pro skid plate

**pics coming**

DIY bed/drawer platform for 5ft bed tacomas, came with my new truck - $400











BAMF behind the grill lightbar bracket with Diode Dynamics SS18 amber combo lightbar - $150



Pelfreybilt IFS skid plate, aluminum - $300 or trade for TRD Pro skid plate

 

These are totally fixable. That little gouge on the uniball and inside the cups is nothin. Can be smoothed out and pressed in like nothing happened. I've rebuilt 2 sets of uppers and the slight gouging is almost guaranteed to happen during install. I've even seen it in brand new uppers when replacing just uniballs. Good deal for someone wanting a nice set of uppers. Little elbow grease and they are good to go.

 

Sold

 

Sold.

 

Sold.

 

Sold.

 

Sold.

 

Sold.

 

If you were closer I might entertain some of this. Especially the washer and dryer. I'll be in mesa for Thanksgiving....
Gas or electric dryer?

 

Gas

 

I have a 1986 Toyota 4Runner 4wd rolling chassis for sale.
I have a title.
No engine, no transmission, no transfer case, no steering column.
What you see is what you get.
Located in the White Mountains.

It will need to be trailered. $500 OBO

 

Damn

 

I know this is from months ago, but do you still have the cam bolts?

Or

ISO: cam alignment bolts, not cross threaded from firestone alignment techs, preferably.

 

I've got a used set..

 

If you don't want @XPOTRPR's bolts, I've got a used set in my garage

 

How are the threads on those nuts
how much would you guys want for them? I can pick up anytime tomorrow but the evening (subject to change).

Same goes for you, appreciate the offer, I would like to get them picked up asap if possible. Have work tomorrow but can make time to go grab.