What Have You Done To Your 4th Gen Today?

Does the Prerunner have the 278hp or 228hp 2.4

 

ECGS needle bearing replaced.. Wasn’t fun but the vibrations are gone!

 

The 278hp tune

 

SealSavers

 

Type R looks good

 

Bonobo front recovery points. Thanks @CrispyTacoLover

 

Looks good!

 

Installed ics fab dash mount. Took them a month to get this to me...

 

Glad it got to you. I have seen some upset Facebook posts about slow shipping and no communication

 

yeah man and thanks, i posted that it took 30 days, some people posted that they are waiting over 36 days :/

 

Rival 4x4 skids stamped 6mm aluminum.

 

please provide details! what extinguisher/mount?

 

Go smaller and easier:

https://elementfire.com/

Many mount options, too.

 

Not offered for Sport or Premium models……..

how many thousands of Sport owners are going to be looking to replace Felt cover…

 

New wheels and tires. Falken Rubitreks on Black Rhino (Bahari is the name of the wheel model I think). I also added a cheap Amazon soft bed cover and some also cheap Amazon side steps. The steps are actually really nice and look good for what they are. I’ll find a link if anyone cares.

 

Extinguisher is am Amerex ABC 2.5lb.
Mounts/straps are QuickFIST (large size), easy to find on Amazon.

The QuickFISTs needed a bit of trimming of length (they allow for 2.5” to 8.5” diameter; just cut the long end off). To install, first remove the wrench roll strap (undo the screw; store the wrench roll under the seat). Reuse the screw and hole for one QuickFIST. For the other QuickFIST I self-tapped into the back wall.

 

What kind of sliders?

 

Did you call them? Might just need the front cross member?

 

Picked it up from the dealer

 

I just got home from a buddy's we put the Sxth element intake and trail tip on. The intake is quite noticeable sounding. I can't tell anything from the tip with the resonator removed. We only jacked up on the rear high mount jack on the drivers side for the exhaust to come out. We didn't touch the spare tire at all..Intake was probably the easiest one I ever did. My buddy's a welder and he seemed impressed by the welds on the tip..Both took less than an hr I will get some pics over the weekend