1st Gen Lunchtable Thread - General Discussion

Almost time
Order is ready for pickup

 

Normally you just send in your 3rd member...sending your whole axle?

 

I wish it was that easy
8” 3rd doesn’t fit in the 8.4 housing

 

Ahhh forgot you were getting a locked setup

Thought you were going aftermarket for a bit

 

I wish I had kept my welded 8.4 instead of dumping money into an elocker swap lol

 

E-Locker just don't got the heart nor the gumption, it breaks easily electronically and it's not a particularly strong gear set

 

Probably me if I ever got a 3D printer

 

yeahh the little side gear in the elocker is more concerning to me than the ring and pinion lol

my gears have survived but it helps that the electronics have failed multiple times and prevented me from using it

 

next set of axles is getting a welded rear and auto locker in the front. no more wonky electronics or air blowing all my gear oil out the vent

 

stock power and 35s is ok

37s or boost is a nono

 

@Kwikvette
You need to stop ignoring this voice
https://www.instagram.com/reel/C_WXW-wRo91/?igsh=MTZhY2FmamRzYzZqNA==

 

Dude spitting facts

 

How much are you into that axle?

 

Nothing yet

 

Oh it's free? That's good, most on Facebook want 1200+

 

Oh no, none yet lol
It’ll be like 6-700 I think we said, been a while since we agreed to it
Def not 1200+, id lean towards an arb at that price
Im aiming to be a bit under 1k by the time I freshen up some seals and wire it up

 

Ah I had alot of faith in mine, change the drums, buy an actuator, run it till the seals go, stand alone harness from this guy https://www.instagram.com/p/C5UnPDYtysJ/?igsh=MTgwcjJyb3dob3c1cA==

 

How much is it from that guy?
I just put the low range offroad one on order an hour ago
Edit: nvm found it